On 20 Apr 01 at 18:18, German Gomez Garcia wrote:
> On Fri, 20 Apr 2001 18:01:59 MET-1 Petr Vandrovec <[email protected]> wrote:
> I've got it conected to the RGB->SVIDEO cable that was included with
> the Matrox G400 MAX, and the SVIDEO is connected to a VIDEO->RF conversor in
> order to distribute to other rooms. And what is the caller when modprobing?
> modprobe? the driver for the g400 i2c?
Yeah. RGB->SVIDEO cabel has connected SDA-SCL together, so when it transmits
zero data bit, it will find clocks held in zero... Caller is i2c-matroxfb
procedure which calls i2c_add_bit_bus() ... It calls it with 1s timeout
too, but it is another story... I believed that it is 100ms timeout...
> > You should compile i2c-algo-bit as module and use insmod it
> > with 'bit_test=1' parameter. It should do some tests on these pins
> > to find whether they are stuck in 0 or in 1. You can also try
> > 'i2c_debug=3' ...
>
> I'll check it and mail you with results.
bit_test=1 should say 'DDC#2: SCL unexpected low while pulling SDA low!'...
Petr Vandrovec
[email protected]