Fix the following warning:
drivers/tty/serial/omap-serial.c: In function serial_omap_rlsi:
drivers/tty/serial/omap-serial.c:496:16: warning: variable ch set but not used [-Wunused-but-set-variable]
The character read is useless according to the table 23-246 of the omap4
TRM. So we can drop it.
Reported-by: Hulk Robot <[email protected]>
Signed-off-by: Xiongfeng Wang <[email protected]>
---
drivers/tty/serial/omap-serial.c | 7 +++++--
1 file changed, 5 insertions(+), 2 deletions(-)
diff --git a/drivers/tty/serial/omap-serial.c b/drivers/tty/serial/omap-serial.c
index 6420ae5..5f808d8 100644
--- a/drivers/tty/serial/omap-serial.c
+++ b/drivers/tty/serial/omap-serial.c
@@ -493,10 +493,13 @@ static unsigned int check_modem_status(struct uart_omap_port *up)
static void serial_omap_rlsi(struct uart_omap_port *up, unsigned int lsr)
{
unsigned int flag;
- unsigned char ch = 0;
+ /*
+ * Read one data character out to avoid stalling the receiver according
+ * to the table 23-246 of the omap4 TRM.
+ */
if (likely(lsr & UART_LSR_DR))
- ch = serial_in(up, UART_RX);
+ serial_in(up, UART_RX);
up->port.icount.rx++;
flag = TTY_NORMAL;
--
1.7.12.4