At the moment, if a Fintek UART is detected, there is no
printed information about this.
The ttyS port is declared as a simple 16550A port, but,
especially when we want to use the RS485 mode, it's
very important understand if the Fintek UART is correctly
detected as expected.
Signed-off-by: Flavio Suligoi <[email protected]>
---
drivers/tty/serial/8250/8250_fintek.c | 25 +++++++++++++++++++++++--
1 file changed, 23 insertions(+), 2 deletions(-)
diff --git a/drivers/tty/serial/8250/8250_fintek.c b/drivers/tty/serial/8250/8250_fintek.c
index 31c9e83ea3cb..ef2303cb5176 100644
--- a/drivers/tty/serial/8250/8250_fintek.c
+++ b/drivers/tty/serial/8250/8250_fintek.c
@@ -97,6 +97,7 @@ struct fintek_8250 {
u16 base_port;
u8 index;
u8 key;
+ const char *chip_name;
};
static u8 sio_read_reg(struct fintek_8250 *pdata, u8 reg)
@@ -140,9 +141,11 @@ static void fintek_8250_exit_key(u16 base_port)
release_region(base_port + ADDR_PORT, 2);
}
-static int fintek_8250_check_id(struct fintek_8250 *pdata)
+static int fintek_8250_check_id(struct fintek_8250 *pdata,
+ struct uart_8250_port *uart)
{
u16 chip;
+ const char *chip_name;
if (sio_read_reg(pdata, VENDOR_ID1) != VENDOR_ID1_VAL)
return -ENODEV;
@@ -155,17 +158,35 @@ static int fintek_8250_check_id(struct fintek_8250 *pdata)
switch (chip) {
case CHIP_ID_F81865:
+ chip_name = "F81865";
+ break;
case CHIP_ID_F81866:
+ chip_name = "F81866";
+ break;
case CHIP_ID_F81966:
+ chip_name = "F81966";
+ break;
case CHIP_ID_F81216AD:
+ chip_name = "F81216AD";
+ break;
case CHIP_ID_F81216H:
+ chip_name = "F81216H";
+ break;
case CHIP_ID_F81216:
+ chip_name = "F81216";
break;
default:
return -ENODEV;
}
pdata->pid = chip;
+
+ pr_info("%s%s%s Fintek %s\n",
+ uart->port.dev ? dev_name(uart->port.dev) : "",
+ uart->port.dev ? ": " : "",
+ uart->port.name,
+ chip_name);
+
return 0;
}
@@ -406,7 +427,7 @@ static int probe_setup_port(struct fintek_8250 *pdata,
if (fintek_8250_enter_key(addr[i], keys[j]))
continue;
- if (fintek_8250_check_id(pdata) ||
+ if (fintek_8250_check_id(pdata, uart) ||
fintek_8250_get_ldn_range(pdata, &min, &max)) {
fintek_8250_exit_key(addr[i]);
continue;
--
2.25.1