1. Rename saved_command_line into boot_command_line.
2. Set command_line as __initdata.
Signed-off-by: Alon Bar-Lev <[email protected]>
---
arch/h8300/kernel/setup.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
Index: linux-2.6.20-rc4-mm1/arch/h8300/kernel/setup.c
===================================================================
--- linux-2.6.20-rc4-mm1.orig/arch/h8300/kernel/setup.c
+++ linux-2.6.20-rc4-mm1/arch/h8300/kernel/setup.c
@@ -54,7 +54,7 @@ unsigned long rom_length;
unsigned long memory_start;
unsigned long memory_end;
-char command_line[COMMAND_LINE_SIZE];
+char __initdata command_line[COMMAND_LINE_SIZE];
extern int _stext, _etext, _sdata, _edata, _sbss, _ebss, _end;
extern int _ramstart, _ramend;
@@ -154,8 +154,8 @@ void __init setup_arch(char **cmdline_p)
#endif
/* Keep a copy of command line */
*cmdline_p = &command_line[0];
- memcpy(saved_command_line, command_line, COMMAND_LINE_SIZE);
- saved_command_line[COMMAND_LINE_SIZE-1] = 0;
+ memcpy(boot_command_line, command_line, COMMAND_LINE_SIZE);
+ boot_command_line[COMMAND_LINE_SIZE-1] = 0;
#ifdef DEBUG
if (strlen(*cmdline_p))
--