Anyone else out there with a Keyspan USB PDA adapter using test12-pre3?
I'm experiencing hangs when I try to send data to my Palm Vx using it.
Locks up the machine hard. No SysRq. No messages. USB serial debug
output doesn't have much either...
Nov 30 00:09:25 viper kernel: keyspan_pda.c: keyspan_pda_write(16)
Nov 30 00:09:25 viper kernel: usbserial.c: serial_write - port 0, 43
byte(s)
Nov 30 00:09:25 viper kernel: keyspan_pda.c: keyspan_pda_write(43)
Nov 30 00:09:25 viper kernel: usbserial.c: serial_write - port 0, 43
byte(s)
Nov 30 00:09:25 viper kernel: keyspan_pda.c: keyspan_pda_write(43)
--
=====================================================================
Mohammad A. Haque http://www.haque.net/
[email protected]
"Alcohol and calculus don't mix. Project Lead
Don't drink and derive." --Unknown http://wm.themes.org/
[email protected]
=====================================================================
On Thu, Nov 30, 2000 at 12:53:40AM -0500, Mohammad A. Haque wrote:
> Anyone else out there with a Keyspan USB PDA adapter using test12-pre3?
> I'm experiencing hangs when I try to send data to my Palm Vx using it.
> Locks up the machine hard. No SysRq. No messages. USB serial debug
> output doesn't have much either...
Are you using the usb-uhci host driver?
If so, the following fix from Georg Acher should do the trick:
-----
Replace line 275 (insert_td())
qh->hw.qh.element = virt_to_bus (new) | UHCI_PTR_TERM;
by
qh->hw.qh.element = virt_to_bus (new) ;
-----
Let me (and the list) know if this doesn't fix your problem.
greg k-h
--
greg@(kroah|wirex).com
http://immunix.org/~greg
Wed, Nov 29, 2000 at 11:44:20PM -0800
X-Operating-System: Linux 2.2.17-immunix (i686)
On Wed, Nov 29, 2000 at 11:44:20PM -0800, Greg KH wrote:
> If so, the following fix from Georg Acher should do the trick:
>
> -----
> Replace line 275 (insert_td())
> qh->hw.qh.element = virt_to_bus (new) | UHCI_PTR_TERM;
> by
> qh->hw.qh.element = virt_to_bus (new) ;
>
> -----
Here's the above in patch form to make it easier for people to apply.
greg k-h
--
greg@(kroah|wirex).com
That fixed it. Thanks
Greg KH wrote:
> Are you using the usb-uhci host driver?
>
> If so, the following fix from Georg Acher should do the trick:
>
> -----
> Replace line 275 (insert_td())
> qh->hw.qh.element = virt_to_bus (new) | UHCI_PTR_TERM;
> by
> qh->hw.qh.element = virt_to_bus (new) ;
>
> -----
>
> Let me (and the list) know if this doesn't fix your problem.
>
> greg k-h
>
--
=====================================================================
Mohammad A. Haque http://www.haque.net/
[email protected]
"Alcohol and calculus don't mix. Project Lead
Don't drink and derive." --Unknown http://wm.themes.org/
[email protected]
=====================================================================