I'm glad to say that this is the first 2.4 kernel that works on my noritake
alpha with a pci-pci bridge.
I have a small problem. If I reboot, the srm console can't boot from dka0.
Doing a: show dev
doesn't list any of the hard drives in the machine.
doing an init causes it to reset and find all the drives again.
--
Lab tests show that use of micro$oft causes cancer in lab animals
On Wed, Dec 06, 2000 at 08:47:23PM -0500, Wakko Warner wrote:
> I'm glad to say that this is the first 2.4 kernel that works on my noritake
> alpha with a pci-pci bridge.
>
> I have a small problem. If I reboot, the srm console can't boot from dka0.
> Doing a: show dev
> doesn't list any of the hard drives in the machine.
> doing an init causes it to reset and find all the drives again.
During boot, the Linux kernel code (on Alpha) changes the PCI resource
settings of cards and bridges alike. Some SRM consoles do not appreciate
this... ;-}
There is code in 2.2 that restores card/bridge settings before exiting
the kernel back to console mode. This code has NOT been ported to 2.4,
due primarily to the size of the changes made to 2.4 in that area.
Could you verify that 2.2 (take the latest, please) DOES exit to SRM
correctly?
A workaround for 2.4 is to set "boot_reset" to ON in SRM, which will
force a full reset before continuing the boot. Yes, I know, for a lot
of situations this is overkill, but at least it will do the right thing
under the above described situations...
Good luck.
--Jay++
-----------------------------------------------------------------------------
Jay A Estabrook Alpha Engineering - LINUX Project
Compaq Computer Corp. - MRO1-2/K20 (508) 467-2080
200 Forest Street, Marlboro MA 01752 [email protected]
-----------------------------------------------------------------------------