Hi list,
On boot kernel 2.4.20-pre5, Intel driver not show auto negociation
Before this version auto negociation running ok.
Intel(R) PRO/100 Network Driver - version 2.1.15-k1
Copyright (c) 2002 Intel Corporation
e100: eth0: Intel(R) 8255x-based Ethernet Adapter
Mem:0xfecff000 IRQ:16 Speed:0 Mbps Dx:N/A
Failed to detect cable link
Speed and duplex will be determined at time of connection
Hardware receive checksums enabled
cpu cycle saver enabled
lspci -vvv
00:08.0 Ethernet controller: Intel Corporation 82557 [Ethernet Pro 100]
(rev 08)
Subsystem: Hewlett-Packard Company: Unknown device 10cb
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop-
ParErr+ Stepping- SERR+ FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 66 (2000ns min, 14000ns max), cache line size 08
Interrupt: pin A routed to IRQ 16
Region 0: Memory at fecff000 (32-bit, non-prefetchable) [size=4K]
Region 1: I/O ports at fcc0 [size=64]
Region 2: Memory at fed00000 (32-bit, non-prefetchable) [size=1M]
Capabilities: [dc] Power Management version 2
Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA
PME(D0+,D1+,D2+,D3hot+,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=2 PME-
Regards
--
Marcus Grando
<marcus at big dot univali dot br>
<marcus at sbh dot eng dot br>