On Sun, Jun 2, 2024 at 2:57 AM Sven Peter via B4 Relay
<[email protected]> wrote:
>
> From: Hector Martin <[email protected]>
>
> This new variant needs a different core2_window1 and always uses
> beamforming.
> The BAR2 also has an offset (RAM start, presumably), so add that.
>
> Signed-off-by: Hector Martin <[email protected]>
> Reviewed-by: Sven Peter <[email protected]>
> [sven: rebased, updated some comments, mentioned 4388 in Kconfig]
> Signed-off-by: Sven Peter <[email protected]>
> ---
> Hi,
>
> This is just a single commit mostly written by Hector that adds support
> for BCM4388 chips. I've just rebased this to the current bluetooth-next
> since it also needs 9dc8ac15ca5 and adjusted some comments.
>
> Best,
>
> Sven
> ---
> drivers/bluetooth/Kconfig | 6 ++--
> drivers/bluetooth/hci_bcm4377.c | 61 +++++++++++++++++++++++++++++++----------
> 2 files changed, 50 insertions(+), 17 deletions(-)
>
> diff --git a/drivers/bluetooth/Kconfig b/drivers/bluetooth/Kconfig
> index 0b5f218ac505..87484f5de8e3 100644
> --- a/drivers/bluetooth/Kconfig
> +++ b/drivers/bluetooth/Kconfig
> @@ -287,12 +287,12 @@ config BT_HCIBCM203X
>
>
> config BT_HCIBCM4377
> - tristate "HCI BCM4377/4378/4387 PCIe driver"
> + tristate "HCI BCM4377/4378/4387/4388 PCIe driver"
> depends on PCI
> select FW_LOADER
> help
> - Support for Broadcom BCM4377/4378/4387 Bluetooth chipsets attached via
> - PCIe. These are usually found in Apple machines.
> + Support for Broadcom BCM4377/4378/4387/4388 Bluetooth chipsets
> + attached via PCIe. These are usually found in Apple machines.
>
> Say Y here to compile support for HCI BCM4377 family devices into the
> kernel or say M to compile it as module (hci_bcm4377).
> diff --git a/drivers/bluetooth/hci_bcm4377.c b/drivers/bluetooth/hci_bcm4377.c
> index e6644cb0163c..77a5454a8721 100644
> --- a/drivers/bluetooth/hci_bcm4377.c
> +++ b/drivers/bluetooth/hci_bcm4377.c
> @@ -1,6 +1,6 @@
> // SPDX-License-Identifier: GPL-2.0-only OR MIT
> /*
> - * Bluetooth HCI driver for Broadcom 4377/4378/4387 devices attached via PCIe
> + * Bluetooth HCI driver for Broadcom 4377/4378/4387/4388 devices attached via PCIe
> *
> * Copyright (C) The Asahi Linux Contributors
> */
> @@ -26,11 +26,13 @@ enum bcm4377_chip {
> BCM4377 = 0,
> BCM4378,
> BCM4387,
> + BCM4388,
> };
>
> #define BCM4377_DEVICE_ID 0x5fa0
> #define BCM4378_DEVICE_ID 0x5f69
> #define BCM4387_DEVICE_ID 0x5f71
> +#define BCM4388_DEVICE_ID 0x5f72
>
> #define BCM4377_TIMEOUT msecs_to_jiffies(1000)
> #define BCM4377_BOOT_TIMEOUT msecs_to_jiffies(5000)
> @@ -488,6 +490,7 @@ struct bcm4377_data;
> * second window in BAR0
> * has_bar0_core2_window2: Set to true if this chip requires the second core's
> * second window to be configured
> + * bar2_offset: Offset to the start of the variables in BAR2
> * clear_pciecfg_subsystem_ctrl_bit19: Set to true if bit 19 in the
> * vendor-specific subsystem control
> * register has to be cleared
> @@ -511,6 +514,7 @@ struct bcm4377_hw {
> u32 bar0_window1;
> u32 bar0_window2;
> u32 bar0_core2_window2;
> + u32 bar2_offset;
>
> unsigned long has_bar0_core2_window2 : 1;
> unsigned long clear_pciecfg_subsystem_ctrl_bit19 : 1;
> @@ -836,8 +840,8 @@ static irqreturn_t bcm4377_irq(int irq, void *data)
> struct bcm4377_data *bcm4377 = data;
> u32 bootstage, rti_status;
>
> - bootstage = ioread32(bcm4377->bar2 + BCM4377_BAR2_BOOTSTAGE);
> - rti_status = ioread32(bcm4377->bar2 + BCM4377_BAR2_RTI_STATUS);
> + bootstage = ioread32(bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_BOOTSTAGE);
> + rti_status = ioread32(bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_RTI_STATUS);
>
> if (bootstage != bcm4377->bootstage ||
> rti_status != bcm4377->rti_status) {
> @@ -1197,6 +1201,14 @@ static int bcm4387_send_calibration(struct bcm4377_data *bcm4377)
> bcm4377->taurus_cal_size);
> }
>
> +static int bcm4388_send_calibration(struct bcm4377_data *bcm4377)
> +{
> + /* BCM4388 always uses beamforming */
> + return __bcm4378_send_calibration(
> + bcm4377, bcm4377->taurus_beamforming_cal_blob,
> + bcm4377->taurus_beamforming_cal_size);
> +}
> +
> static const struct firmware *bcm4377_request_blob(struct bcm4377_data *bcm4377,
> const char *suffix)
> {
> @@ -1820,8 +1832,8 @@ static int bcm4377_boot(struct bcm4377_data *bcm4377)
> int ret = 0;
> u32 bootstage, rti_status;
>
> - bootstage = ioread32(bcm4377->bar2 + BCM4377_BAR2_BOOTSTAGE);
> - rti_status = ioread32(bcm4377->bar2 + BCM4377_BAR2_RTI_STATUS);
> + bootstage = ioread32(bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_BOOTSTAGE);
> + rti_status = ioread32(bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_RTI_STATUS);
>
> if (bootstage != 0) {
> dev_err(&bcm4377->pdev->dev, "bootstage is %d and not 0\n",
> @@ -1855,9 +1867,12 @@ static int bcm4377_boot(struct bcm4377_data *bcm4377)
> iowrite32(BCM4377_DMA_MASK,
> bcm4377->bar0 + BCM4377_BAR0_HOST_WINDOW_SIZE);
>
> - iowrite32(lower_32_bits(fw_dma), bcm4377->bar2 + BCM4377_BAR2_FW_LO);
> - iowrite32(upper_32_bits(fw_dma), bcm4377->bar2 + BCM4377_BAR2_FW_HI);
> - iowrite32(fw->size, bcm4377->bar2 + BCM4377_BAR2_FW_SIZE);
> + iowrite32(lower_32_bits(fw_dma),
> + bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_FW_LO);
> + iowrite32(upper_32_bits(fw_dma),
> + bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_FW_HI);
> + iowrite32(fw->size,
> + bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_FW_SIZE);
> iowrite32(0, bcm4377->bar0 + BCM4377_BAR0_FW_DOORBELL);
>
> dev_dbg(&bcm4377->pdev->dev, "waiting for firmware to boot\n");
> @@ -1914,16 +1929,16 @@ static int bcm4377_setup_rti(struct bcm4377_data *bcm4377)
> dev_dbg(&bcm4377->pdev->dev, "RTI is in state 1\n");
>
> /* allow access to the entire IOVA space again */
> - iowrite32(0, bcm4377->bar2 + BCM4377_BAR2_RTI_WINDOW_LO);
> - iowrite32(0, bcm4377->bar2 + BCM4377_BAR2_RTI_WINDOW_HI);
> + iowrite32(0, bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_RTI_WINDOW_LO);
> + iowrite32(0, bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_RTI_WINDOW_HI);
> iowrite32(BCM4377_DMA_MASK,
> - bcm4377->bar2 + BCM4377_BAR2_RTI_WINDOW_SIZE);
> + bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_RTI_WINDOW_SIZE);
>
> /* setup "Converged IPC" context */
> iowrite32(lower_32_bits(bcm4377->ctx_dma),
> - bcm4377->bar2 + BCM4377_BAR2_CONTEXT_ADDR_LO);
> + bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_CONTEXT_ADDR_LO);
> iowrite32(upper_32_bits(bcm4377->ctx_dma),
> - bcm4377->bar2 + BCM4377_BAR2_CONTEXT_ADDR_HI);
> + bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_CONTEXT_ADDR_HI);
> iowrite32(2, bcm4377->bar0 + BCM4377_BAR0_RTI_CONTROL);
>
> ret = wait_for_completion_interruptible_timeout(&bcm4377->event,
> @@ -2489,6 +2504,21 @@ static const struct bcm4377_hw bcm4377_hw_variants[] = {
> .send_calibration = bcm4387_send_calibration,
> .send_ptb = bcm4378_send_ptb,
> },
> +
> + [BCM4388] = {
> + .id = 0x4388,
> + .otp_offset = 0x415c,
> + .bar2_offset = 0x200000,
> + .bar0_window1 = 0x18002000,
> + .bar0_window2 = 0x18109000,
> + .bar0_core2_window2 = 0x18106000,
> + .has_bar0_core2_window2 = true,
> + .broken_mws_transport_config = true,
> + .broken_le_coded = true,
> + .broken_le_ext_adv_report_phy = true,
> + .send_calibration = bcm4388_send_calibration,
> + .send_ptb = bcm4378_send_ptb,
> + },
> };
>
> #define BCM4377_DEVID_ENTRY(id) \
> @@ -2502,6 +2532,7 @@ static const struct pci_device_id bcm4377_devid_table[] = {
> BCM4377_DEVID_ENTRY(4377),
> BCM4377_DEVID_ENTRY(4378),
> BCM4377_DEVID_ENTRY(4387),
> + BCM4377_DEVID_ENTRY(4388),
> {},
> };
> MODULE_DEVICE_TABLE(pci, bcm4377_devid_table);
> @@ -2516,7 +2547,7 @@ static struct pci_driver bcm4377_pci_driver = {
> module_pci_driver(bcm4377_pci_driver);
>
> MODULE_AUTHOR("Sven Peter <[email protected]>");
> -MODULE_DESCRIPTION("Bluetooth support for Broadcom 4377/4378/4387 devices");
> +MODULE_DESCRIPTION("Bluetooth support for Broadcom 4377/4378/4387/4388 devices");
> MODULE_LICENSE("Dual MIT/GPL");
> MODULE_FIRMWARE("brcm/brcmbt4377*.bin");
> MODULE_FIRMWARE("brcm/brcmbt4377*.ptb");
> @@ -2524,3 +2555,5 @@ MODULE_FIRMWARE("brcm/brcmbt4378*.bin");
> MODULE_FIRMWARE("brcm/brcmbt4378*.ptb");
> MODULE_FIRMWARE("brcm/brcmbt4387*.bin");
> MODULE_FIRMWARE("brcm/brcmbt4387*.ptb");
> +MODULE_FIRMWARE("brcm/brcmbt4388*.bin");
> +MODULE_FIRMWARE("brcm/brcmbt4388*.ptb");
>
> ---
> base-commit: 3c376f35eb13a144d5039d911b35110c2beef815
> change-id: 20240602-btbcm4388-431aed90d763
>
This looks good to me.
Reviewed-by: Neal Gompa <[email protected]>
--
真実はいつも一つ！/ Always, there's only one truth!