This patch enables draft-802.11s Mesh Point operation. For that we need mesh
beaconing. This seems to work fine when tested against a Zydas interface but I
would appreciate it if someone who knows ath5k could check this over. My
hardware is an AR5212/AR5213 PCI card.
Signed-off-by: Andrey Yurovsky <[email protected]>
---
diff --git a/drivers/net/wireless/ath5k/base.c b/drivers/net/wireless/ath5k/base.c
index 217d506..6d9f4e1 100644
--- a/drivers/net/wireless/ath5k/base.c
+++ b/drivers/net/wireless/ath5k/base.c
@@ -1425,7 +1425,8 @@ ath5k_beaconq_config(struct ath5k_softc *sc)
ret = ath5k_hw_get_tx_queueprops(ah, sc->bhalq, &qi);
if (ret)
return ret;
- if (sc->opmode == IEEE80211_IF_TYPE_AP) {
+ if (sc->opmode == IEEE80211_IF_TYPE_AP ||
+ sc->opmode == IEEE80211_IF_TYPE_MESH_POINT) {
/*
* Always burst out beacon and CAB traffic
* (aifs = cwmin = cwmax = 0)
@@ -2911,6 +2912,7 @@ static void ath5k_configure_filter(struct ieee80211_hw *hw,
if (sc->opmode != IEEE80211_IF_TYPE_STA)
rfilt |= AR5K_RX_FILTER_PROBEREQ;
if (sc->opmode != IEEE80211_IF_TYPE_AP &&
+ sc->opmode != IEEE80211_IF_TYPE_MESH_POINT &&
test_bit(ATH_STAT_PROMISC, sc->status))
rfilt |= AR5K_RX_FILTER_PROM;
if (sc->opmode == IEEE80211_IF_TYPE_STA ||
diff --git a/drivers/net/wireless/ath5k/hw.c b/drivers/net/wireless/ath5k/hw.c
index c6d12c5..8854820 100644
--- a/drivers/net/wireless/ath5k/hw.c
+++ b/drivers/net/wireless/ath5k/hw.c
@@ -2326,6 +2326,7 @@ int ath5k_hw_set_opmode(struct ath5k_hw *ah)
break;
case IEEE80211_IF_TYPE_AP:
+ case IEEE80211_IF_TYPE_MESH_POINT:
pcu_reg |= AR5K_STA_ID1_AP | AR5K_STA_ID1_RTS_DEF_ANTENNA |
(ah->ah_version == AR5K_AR5210 ?
AR5K_STA_ID1_NO_PSPOLL : 0);