The TSF is already reset properly via mac80211's callback.
Resetting it in config_interface() is not needed.
Signed-off-by: Sujith <[email protected]>
---
drivers/net/wireless/ath9k/main.c | 11 -----------
1 files changed, 0 insertions(+), 11 deletions(-)
diff --git a/drivers/net/wireless/ath9k/main.c b/drivers/net/wireless/ath9k/main.c
index b349e91..d2b53b5 100644
--- a/drivers/net/wireless/ath9k/main.c
+++ b/drivers/net/wireless/ath9k/main.c
@@ -1239,17 +1239,6 @@ static int ath9k_config_interface(struct ieee80211_hw *hw,
/* Set aggregation protection mode parameters */
sc->sc_config.ath_aggr_prot = 0;
- /*
- * Reset our TSF so that its value is lower than the
- * beacon that we are trying to catch.
- * Only then hw will update its TSF register with the
- * new beacon. Reset the TSF before setting the BSSID
- * to avoid allowing in any frames that would update
- * our TSF only to have us clear it
- * immediately thereafter.
- */
- ath9k_hw_reset_tsf(sc->sc_ah);
-
/* Disable BMISS interrupt when we're not associated */
ath9k_hw_set_interrupts(sc->sc_ah,
sc->sc_imask &
--
1.6.0.3