Hi,
My ath9k refuses to go into AP mode.
I am using:
- a 5416 wireless card (WMP300Nv2)
- linuxkernel 2.7.27.6
- hostapd 0.6.5
- wireless-testing 11-11-2008
When I try to set the ath9k in AP with hostapd I get:
xxx:/home/xxx# hostapd -dd /etc/hostapd/hostapd.conf
Configuration file: /etc/hostapd/hostapd.conf
ctrl_interface_group=0
Opening raw packet socket for ifindex 0
BSS count 1, BSSID mask ff:ff:ff:ff:ff:ff (0 bits)
SIOCGIWRANGE: WE(compiled)=22 WE(source)=21 enc_capa=0xf
Failed to update rate sets in kernel module
RATE[0] rate=10 flags=0x2
RATE[1] rate=20 flags=0x2
RATE[2] rate=55 flags=0x2
RATE[3] rate=110 flags=0x2
RATE[4] rate=60 flags=0x0
RATE[5] rate=90 flags=0x0
RATE[6] rate=120 flags=0x0
RATE[7] rate=180 flags=0x0
RATE[8] rate=240 flags=0x0
RATE[9] rate=360 flags=0x0
RATE[10] rate=480 flags=0x0
RATE[11] rate=540 flags=0x0
Could not set passive scanning: Unknown error 4294967295
Flushing old station entries
Deauthenticate all stations
Mode: IEEE 802.11g Channel: 8 Frequency: 2447 MHz
Failed to set CTS protect in kernel driver
Failed to set Short Slot Time option in kernel driver
Could not set preamble for kernel driver
ioctl[SIOCSIWFRAG]: Operation not supported
Could not set fragmentation threshold for kernel driver
wlan0: Unable to setup interface.
Flushing old station entries
Deauthenticate all stations
rmdir[ctrl_interface]: No such file or directory
iwconfig shows:
wlan0 IEEE 802.11bgn Mode:Master Frequency:2.447 GHz Tx-Power=27 dBm
Retry min limit:7 RTS thr=2347 B Fragment thr=2346 B
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
the SSID entry is missing here.
and iw list shows:
Wiphy phy0
Band 1:
Frequencies:
* 2412 MHz
* 2417 MHz
* 2422 MHz
* 2427 MHz
* 2432 MHz
* 2437 MHz
* 2442 MHz
* 2447 MHz
* 2452 MHz
* 2457 MHz
* 2462 MHz
Bitrates:
* 1.0 Mbps
* 2.0 Mbps
* 5.5 Mbps
* 11.0 Mbps
* 6.0 Mbps
* 9.0 Mbps
* 12.0 Mbps
* 18.0 Mbps
* 24.0 Mbps
* 36.0 Mbps
* 48.0 Mbps
* 54.0 Mbps
Supported interface modes:
* IBSS
* Station
* AP
* AP(VLAN)
* Monitor
Or am I something missing to get it work. A previous version did set the
ath9k ok as AP, however it hanged the kernel after some time.
TIA,
Willem
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.