* Set correct xpd curve indices for high/low gain curves during
rfbuffer setup on RF5112B with both calibration curves available.
* Don't return zero min power when we have the same pcdac value
twice because it breaks interpolation. Instead return the right
x barrier as we do when we have equal power levels for 2 different
pcdac values.
Signed-off-by: Nick Kossifidis <[email protected]>
Acked-by: Bob Copeland <[email protected]>
---
drivers/net/wireless/ath/ath5k/phy.c | 24 +++++++++++++++++-------
1 files changed, 17 insertions(+), 7 deletions(-)
diff --git a/drivers/net/wireless/ath/ath5k/phy.c b/drivers/net/wireless/ath/ath5k/phy.c
index 2075ba9..6afba98 100644
--- a/drivers/net/wireless/ath/ath5k/phy.c
+++ b/drivers/net/wireless/ath/ath5k/phy.c
@@ -740,13 +740,22 @@ int ath5k_hw_rfregs_init(struct ath5k_hw *ah, struct ieee80211_channel *channel,
AR5K_RF_XPD_GAIN, true);
} else {
- /* TODO: Set high and low gain bits */
- ath5k_hw_rfb_op(ah, rf_regs,
- ee->ee_x_gain[ee_mode],
+ u8 *pdg_curve_to_idx = ee->ee_pdc_to_idx[ee_mode];
+ if (ee->ee_pd_gains[ee_mode] > 1) {
+ ath5k_hw_rfb_op(ah, rf_regs,
+ pdg_curve_to_idx[0],
AR5K_RF_PD_GAIN_LO, true);
- ath5k_hw_rfb_op(ah, rf_regs,
- ee->ee_x_gain[ee_mode],
+ ath5k_hw_rfb_op(ah, rf_regs,
+ pdg_curve_to_idx[1],
AR5K_RF_PD_GAIN_HI, true);
+ } else {
+ ath5k_hw_rfb_op(ah, rf_regs,
+ pdg_curve_to_idx[0],
+ AR5K_RF_PD_GAIN_LO, true);
+ ath5k_hw_rfb_op(ah, rf_regs,
+ pdg_curve_to_idx[0],
+ AR5K_RF_PD_GAIN_HI, true);
+ }
/* Lower synth voltage on Rev 2 */
ath5k_hw_rfb_op(ah, rf_regs, 2,
@@ -1896,8 +1905,9 @@ ath5k_get_linear_pcdac_min(const u8 *stepL, const u8 *stepR,
s16 min_pwrL, min_pwrR;
s16 pwr_i;
- if (WARN_ON(stepL[0] == stepL[1] || stepR[0] == stepR[1]))
- return 0;
+ /* Some vendors write the same pcdac value twice !!! */
+ if (stepL[0] == stepL[1] || stepR[0] == stepR[1])
+ return max(pwrL[0], pwrR[0]);
if (pwrL[0] == pwrL[1])
min_pwrL = pwrL[0];