Instead of configuring tx power unconditionally, check for
IEEE80211_CONF_CHANGE_POWER and configure it only when stack
sets this flag
Signed-off-by: Nishant Sarmukadam <[email protected]>
---
drivers/net/wireless/mwl8k.c | 9 ++++++---
1 files changed, 6 insertions(+), 3 deletions(-)
diff --git a/drivers/net/wireless/mwl8k.c b/drivers/net/wireless/mwl8k.c
index 53920f3..45b1704 100644
--- a/drivers/net/wireless/mwl8k.c
+++ b/drivers/net/wireless/mwl8k.c
@@ -4463,9 +4463,12 @@ static int mwl8k_config(struct ieee80211_hw *hw, u32 changed)
conf->power_level = 18;
if (priv->ap_fw) {
- rc = mwl8k_cmd_tx_power(hw, conf, conf->power_level);
- if (rc)
- goto out;
+
+ if (conf->flags & IEEE80211_CONF_CHANGE_POWER) {
+ rc = mwl8k_cmd_tx_power(hw, conf, conf->power_level);
+ if (rc)
+ goto out;
+ }
rc = mwl8k_cmd_rf_antenna(hw, MWL8K_RF_ANTENNA_RX, 0x3);
if (rc)
--
1.6.0.3