* Do not set/clear TSF when adding/deleting an interface.
This should be done when the BSS is set up and should also
take into account the existence of other interfaces.
* Set opmode explicitly.
* ANI setup needs to be decided based on multiple interfaces.
This can be done via the bss_info_changed() callback.
Signed-off-by: Sujith Manoharan <[email protected]>
---
drivers/net/wireless/ath/ath9k/main.c | 17 ++---------------
1 file changed, 2 insertions(+), 15 deletions(-)
diff --git a/drivers/net/wireless/ath/ath9k/main.c b/drivers/net/wireless/ath/ath9k/main.c
index 1265add..2619bd3 100644
--- a/drivers/net/wireless/ath/ath9k/main.c
+++ b/drivers/net/wireless/ath/ath9k/main.c
@@ -913,11 +913,9 @@ static void ath9k_calculate_summary_state(struct ieee80211_hw *hw,
if (iter_data.naps > 0) {
ath9k_hw_set_tsfadjust(ah, true);
- set_bit(SC_OP_TSF_RESET, &sc->sc_flags);
ah->opmode = NL80211_IFTYPE_AP;
} else {
ath9k_hw_set_tsfadjust(ah, false);
- clear_bit(SC_OP_TSF_RESET, &sc->sc_flags);
if (iter_data.nmeshes)
ah->opmode = NL80211_IFTYPE_MESH_POINT;
@@ -929,25 +927,14 @@ static void ath9k_calculate_summary_state(struct ieee80211_hw *hw,
ah->opmode = NL80211_IFTYPE_STATION;
}
+ ath9k_hw_setopmode(ah);
+
if ((iter_data.nstations + iter_data.nadhocs + iter_data.nmeshes) > 0)
ah->imask |= ATH9K_INT_TSFOOR;
else
ah->imask &= ~ATH9K_INT_TSFOOR;
ath9k_hw_set_interrupts(ah);
-
- if (iter_data.naps > 0) {
- sc->sc_ah->stats.avgbrssi = ATH_RSSI_DUMMY_MARKER;
-
- if (!common->disable_ani) {
- set_bit(SC_OP_ANI_RUN, &sc->sc_flags);
- ath_start_ani(common);
- }
-
- } else {
- clear_bit(SC_OP_ANI_RUN, &sc->sc_flags);
- del_timer_sync(&common->ani.timer);
- }
}
static int ath9k_add_interface(struct ieee80211_hw *hw,
--
1.7.11.1