BIT(0) in MT_EE_NIC_CONF_1 is use to notify the driver if the radio RF
switch is controlled through a gpio. Use dev_debug instead of dev_err
to log this info.
Signed-off-by: Lorenzo Bianconi <[email protected]>
---
drivers/net/wireless/mediatek/mt76/mt76x0/eeprom.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/net/wireless/mediatek/mt76/mt76x0/eeprom.c b/drivers/net/wireless/mediatek/mt76/mt76x0/eeprom.c
index dd66fd12a2e6..cea24213186c 100644
--- a/drivers/net/wireless/mediatek/mt76/mt76x0/eeprom.c
+++ b/drivers/net/wireless/mediatek/mt76/mt76x0/eeprom.c
@@ -68,7 +68,7 @@ static void mt76x0_set_chip_cap(struct mt76x02_dev *dev)
nic_conf1 &= 0xff00;
if (nic_conf1 & MT_EE_NIC_CONF_1_HW_RF_CTRL)
- dev_err(dev->mt76.dev,
+ dev_dbg(dev->mt76.dev,
"driver does not support HW RF ctrl\n");
if (!mt76x02_field_valid(nic_conf0 >> 8))
--
2.30.2