This patch makes duration in scan request be applicable when using
SW scan, but only accepts durations greater than the default value for
the following reasons:
1. Most APs have a beacoon interval of 100ms.
2. Sending and receiving probe require some delay.
3. Setting channel to HW also requires some delays
Signed-off-by: Michael-CY Lee <[email protected]>
---
net/mac80211/scan.c | 10 ++++++++--
1 file changed, 8 insertions(+), 2 deletions(-)
diff --git a/net/mac80211/scan.c b/net/mac80211/scan.c
index 645355e5f1bc..8adcb23262f5 100644
--- a/net/mac80211/scan.c
+++ b/net/mac80211/scan.c
@@ -671,7 +671,10 @@ static void ieee80211_scan_state_send_probe(struct ieee80211_local *local,
* After sending probe requests, wait for probe responses
* on the channel.
*/
- *next_delay = IEEE80211_CHANNEL_TIME;
+ *next_delay = msecs_to_jiffies(scan_req->duration) >
+ IEEE80211_PROBE_DELAY + IEEE80211_CHANNEL_TIME ?
+ msecs_to_jiffies(scan_req->duration) - IEEE80211_PROBE_DELAY :
+ IEEE80211_CHANNEL_TIME;
local->next_scan_state = SCAN_DECISION;
}
@@ -994,7 +997,10 @@ static void ieee80211_scan_state_set_channel(struct ieee80211_local *local,
*/
if ((chan->flags & (IEEE80211_CHAN_NO_IR | IEEE80211_CHAN_RADAR)) ||
!scan_req->n_ssids) {
- *next_delay = IEEE80211_PASSIVE_CHANNEL_TIME;
+ *next_delay = msecs_to_jiffies(scan_req->duration) >
+ IEEE80211_PASSIVE_CHANNEL_TIME ?
+ msecs_to_jiffies(scan_req->duration) :
+ IEEE80211_PASSIVE_CHANNEL_TIME;
local->next_scan_state = SCAN_DECISION;
if (scan_req->n_ssids)
set_bit(SCAN_BEACON_WAIT, &local->scanning);
--
2.25.1