Vasanthakumar Thiagarajan ([email protected])

Number of posts: 486 (0.87 per day)
First post: 2009-11-17 14:48:10
Last post: 2011-06-01 13:44:32

Next Page
Date List Subject
2011-06-01 13:44:32 linux-wireless [PATCH] ath6kl: Fix a kernel panic during suspend/resume
2011-05-09 09:39:17 linux-wireless Re: [RFC] ath9k: make npending frames check as bool
2011-05-09 09:29:06 linux-wireless Re: [RFC] ath9k: make npending frames check as bool
2011-05-07 16:02:31 linux-wireless Re: [PATCH 1/2] ath6kl: Remove dead code with undefined EXPORT_HCI_BRIDGE_INTERFACE
2011-05-07 10:29:37 linux-wireless Re: [PATCH 1/2] ath6kl: Remove dead code with undefined EXPORT_HCI_BRIDGE_INTERFACE
2011-05-06 16:15:49 linux-wireless Re: [RFC] ath9k: make npending frames check as bool
2011-05-04 15:50:50 linux-wireless [PATCH 2/2] ath6kl: Merge Bootloader Management Interface (BMI) related header files into one
2011-05-04 15:50:47 linux-wireless [PATCH 1/2] ath6kl: Remove dead code with undefined EXPORT_HCI_BRIDGE_INTERFACE
2011-05-04 08:50:01 linux-wireless [PATCH 5/5] ath6kl: Remove ununsed macros from gpio_reg.h
2011-05-04 08:46:56 linux-wireless [PATCH 1/5] ath6kl: Remove somemore unused header files
2011-04-29 04:43:32 linux-wireless Re: [RFC/RFT 4/9] ath9k_hw: config diversity based on eeprom contents
2011-04-29 04:20:49 linux-wireless Re: [RFC/RFT 3/9] ath9k_hw: define registers/macros to support Antenna diversity
2011-04-29 04:10:50 linux-wireless Re: [RFC/RFT 1/9] ath9k_hw: make antenna diversity modules chip specific
2011-04-21 13:03:17 linux-wireless [PATCH 2/2] ath9k: Fix warning: symbol 'ath9k_platform_id_table' was not declared. Should it be static?
2011-04-21 13:03:16 linux-wireless [PATCH 1/2] ath9k: Fix bug in configuring hw timer
2011-04-20 04:56:05 linux-wireless [PATCH V3 04/22] ath9k_hw: Configure pll control register accordingly for AR9340
2011-04-20 04:35:43 linux-wireless Re: [PATCH V2 04/22] ath9k_hw: Configure pll control register accordingly for AR9340
2011-04-19 14:03:21 linux-wireless [PATCH V2 20/22] ath9k_hw: Assign macversion based on devid for built-in wmac
2011-04-19 14:03:19 linux-wireless [PATCH V2 12/22] ath9k_hw: Fix register offset AR_PHY_65NM_CH0_THERM for AR9340
2011-04-19 14:03:17 linux-wireless [PATCH V2 07/22] ath9k_hw: Don't do ani initialization for AR9340
2011-04-19 14:03:15 linux-wireless [PATCH V2 06/22] ath9k_hw: Initialize mode registers from initvals.h for AR9340
2011-04-19 14:03:14 linux-wireless [PATCH V2 01/22] ath9k_hw: Define devid and mac version for AR9340
2011-04-19 13:59:48 linux-wireless [PATCH V2 22/22] ath9k_hw: Enable AR9340 support
2011-04-19 13:59:46 linux-wireless [PATCH V2 21/22] ath9k_hw: Disable INTR_HOST1_FATAL to avoid interrupt strom with ar9430
2011-04-19 13:59:43 linux-wireless [PATCH V2 19/22] ath9k: Add AR9340 platform id to id table
2011-04-19 13:59:42 linux-wireless [PATCH V2 18/22] ath9k_hw: Read iq calibration data only for active chains
2011-04-19 13:59:40 linux-wireless [PATCH V2 17/22] ath9k_hw: Configure chain switch table and attenuation control only for active chains
2011-04-19 13:59:38 linux-wireless [PATCH V2 16/22] ath9k_hw: Enable byte Tx/Rx data swap for AR9340
2011-04-19 13:59:36 linux-wireless [PATCH V2 15/22] ath9k_hw: Configure tuning capacitance value for AR9340 as well
2011-04-19 13:59:35 linux-wireless [PATCH V2 14/22] ath9k_hw: Skip internal regulator configuration for AR9340
2011-04-19 13:59:33 linux-wireless [PATCH V2 13/22] ath9k_hw: Don't configure AR_CH0_THERM for AR9340
2011-04-19 13:59:31 linux-wireless [PATCH V2 11/22] ath9k_hw: Clean up rx/tx chain configuration before AGC/IQ cal
2011-04-19 13:59:30 linux-wireless [PATCH V2 10/22] ath9k_hw: Configure RF channel freqency for AR9340
2011-04-19 13:59:28 linux-wireless [PATCH V2 09/22] ath9k_hw: Read spur frequency information from eeprom for AR9340
2011-04-19 13:59:26 linux-wireless [PATCH V2 08/22] ath9k_hw: Initialize tx and rx gain table from initvals.h for ar9340
2011-04-19 13:59:20 linux-wireless [PATCH V2 05/22] ath9k_hw: Add initvals.h for ar9340
2011-04-19 13:59:19 linux-wireless [PATCH V2 04/22] ath9k_hw: Configure pll control register accordingly for AR9340
2011-04-19 13:59:17 linux-wireless [PATCH V2 03/22] ath9k_hw: Get AHB clock information from ath9k_platform_data
2011-04-19 13:59:15 linux-wireless [PATCH V2 02/22] ath9k_hw: Take care of few host interface register changes for AR9340
2011-04-19 13:59:13 linux-wireless [PATCH V2 00/22] Add support for AR9340
2011-04-19 05:56:39 linux-wireless Re: [PATCH 02/22] ath9k_hw: Take care of few host interface register changes for AR9340
2011-04-19 05:49:23 linux-wireless Re: [PATCH 03/22] ath9k_hw: Introduce a bool for 25mhz clock and populate it
2011-04-12 14:33:27 linux-wireless Re: [PATCH 03/22] ath9k_hw: Introduce a bool for 25mhz clock and populate it
2011-04-12 14:00:52 linux-wireless Re: [PATCH 03/22] ath9k_hw: Introduce a bool for 25mhz clock and populate it
2011-04-12 13:18:58 linux-wireless [PATCH 22/22] ath9k_hw: Enable AR9340 support
2011-04-12 13:18:53 linux-wireless [PATCH 21/22] ath9k_hw: Disable INTR_HOST1_FATAL to avoid interrupt strom with ar9430
2011-04-12 13:18:49 linux-wireless [PATCH 18/22] ath9k_hw: Read iq calibration data only for active chains
2011-04-12 13:18:43 linux-wireless [PATCH 17/22] ath9k_hw: Configure chain switch table and attenuation control only for active chains
2011-04-12 13:18:38 linux-wireless [PATCH 15/22] ath9k_hw: Configure tuning capacitance value for AR9340 as well
2011-04-12 13:18:33 linux-wireless [PATCH 14/22] ath9k_hw: Skip internal regulator configuration for AR9340
2011-04-12 13:18:28 linux-wireless [PATCH 11/22] ath9k_hw: Clean up rx/tx chain configuration before AGC/IQ cal