From: Guan Xuetao <[email protected]>
default config file for debugger
Signed-off-by: Guan Xuetao <[email protected]>
---
arch/unicore32/configs/debug_defconfig | 208
++++++++++++++++++++++++++++++++
1 files changed, 208 insertions(+), 0 deletions(-)
diff --git a/arch/unicore32/configs/debug_defconfig
b/arch/unicore32/configs/debug_defconfig
new file mode 100644
index 0000000..33e4959
--- /dev/null
+++ b/arch/unicore32/configs/debug_defconfig
@@ -0,0 +1,208 @@
+### General setup
+CONFIG_EXPERIMENTAL=y
+CONFIG_LOCALVERSION="-debug"
+CONFIG_SWAP=y
+CONFIG_SYSVIPC=y
+CONFIG_POSIX_MQUEUE=y
+CONFIG_HOTPLUG=y
+# Initial RAM filesystem and RAM disk (initramfs/initrd) support
+#CONFIG_BLK_DEV_INITRD=y
+#CONFIG_INITRAMFS_SOURCE="arch/unicore/ramfs/ramfs_config"
+
+### Enable loadable module support
+CONFIG_MODULES=n
+CONFIG_MODULE_UNLOAD=y
+
+### System Type
+CONFIG_ARCH_PUV3=y
+# Board Selection
+CONFIG_PUV3_NB0916=y
+# Processor Features
+CONFIG_CPU_DCACHE_LINE_DISABLE=y
+CONFIG_CPU_TLB_SINGLE_ENTRY_DISABLE=n
+
+### Bus support
+CONFIG_PCI=y
+CONFIG_PCI_LEGACY=n
+
+### Boot options
+# for debug, adding: earlyprintk=ocd,keep initcall_debug
+# others support: test_suspend=mem root=/dev/sda
+# hibernate support: resume=/dev/sda3
+CONFIG_CMDLINE="mem=512M earlyprintk=ocd,keep ignore_loglevel
video=unifb:1024x600-16@75 root=/dev/nfs rw
nfsroot=192.168.10.88:/home/udb/nfs/,rsize=1024,wsize=1024
ip=192.168.10.83:192.168.10.88:192.168.10.1:255.255.255.0::eth0:off"
+CONFIG_CMDLINE_FORCE=y
+
+### Power management options
+CONFIG_PM=y
+CONFIG_HIBERNATION=y
+CONFIG_PM_STD_PARTITION="/dev/sda3"
+CONFIG_CPU_FREQ=n
+CONFIG_CPU_FREQ_DEFAULT_GOV_USERSPACE=y
+
+### Networking support
+CONFIG_NET=y
+# Networking options
+CONFIG_PACKET=m
+CONFIG_UNIX=m
+# TCP/IP networking
+CONFIG_INET=y
+CONFIG_IP_MULTICAST=y
+CONFIG_IP_PNP=y
+CONFIG_IPV6=n
+# Wireless
+CONFIG_WIRELESS=y
+CONFIG_WIRELESS_EXT=y
+CONFIG_MAC80211=m
+
+### PKUnity SoC Features
+CONFIG_USB_WLAN_HED_AQ3=n
+CONFIG_USB_CMMB_INNOFIDEI=n
+CONFIG_I2C_BATTERY_BQ27200=n
+CONFIG_I2C_EEPROM_AT24=n
+CONFIG_LCD_BACKLIGHT=n
+
+CONFIG_PUV3_RTC=y
+CONFIG_PUV3_UMAL=y
+CONFIG_PUV3_UNIGFX=y
+CONFIG_PUV3_MUSB=n
+CONFIG_PUV3_AC97=n
+CONFIG_PUV3_NAND=n
+CONFIG_PUV3_MMC=n
+CONFIG_PUV3_UART=n
+
+### Device Drivers
+# Memory Technology Device (MTD) support
+CONFIG_MTD=m
+CONFIG_MTD_UBI=m
+CONFIG_MTD_PARTITIONS=y
+CONFIG_MTD_CHAR=m
+CONFIG_MTD_BLKDEVS=m
+# RAM/ROM/Flash chip drivers
+CONFIG_MTD_CFI=m
+CONFIG_MTD_JEDECPROBE=m
+CONFIG_MTD_CFI_AMDSTD=m
+# Mapping drivers for chip access
+CONFIG_MTD_PHYSMAP=m
+
+# Block devices
+CONFIG_BLK_DEV_LOOP=m
+
+# SCSI device support
+CONFIG_SCSI=y
+CONFIG_BLK_DEV_SD=y
+CONFIG_BLK_DEV_SR=m
+CONFIG_CHR_DEV_SG=m
+
+# Serial ATA (prod) and Parallel ATA (experimental) drivers
+CONFIG_ATA=y
+CONFIG_SATA_VIA=y
+
+# Network device support
+CONFIG_NETDEVICES=y
+CONFIG_NET_ETHERNET=y
+CONFIG_NETDEV_1000=y
+# Wireless LAN
+CONFIG_WLAN_80211=n
+CONFIG_RT2X00=n
+CONFIG_RT73USB=n
+
+# Input device support
+CONFIG_INPUT_EVDEV=m
+# Keyboards
+CONFIG_KEYBOARD_GPIO=m
+
+# Hardware Monitoring support
+#CONFIG_SENSORS_LM75=m
+# Generic Thermal sysfs driver
+#CONFIG_THERMAL=m
+#CONFIG_THERMAL_HWMON=y
+
+# Multimedia support
+CONFIG_MEDIA_SUPPORT=n
+CONFIG_VIDEO_DEV=n
+CONFIG_USB_VIDEO_CLASS=n
+
+# Graphics support
+# Console display driver support
+CONFIG_VGA_CONSOLE=n
+CONFIG_FRAMEBUFFER_CONSOLE=y
+CONFIG_FONTS=y
+CONFIG_FONT_8x8=y
+CONFIG_FONT_8x16=y
+# Bootup logo
+CONFIG_LOGO=n
+
+# Sound card support
+CONFIG_SOUND=m
+# Advanced Linux Sound Architecture
+CONFIG_SND=m
+CONFIG_SND_MIXER_OSS=m
+CONFIG_SND_PCM_OSS=m
+
+# USB support
+CONFIG_USB_ARCH_HAS_HCD=n
+CONFIG_USB=n
+CONFIG_USB_DEVICEFS=n
+CONFIG_USB_PRINTER=n
+CONFIG_USB_STORAGE=n
+# Inventra Highspeed Dual Role Controller
+CONFIG_USB_MUSB_HDRC=n
+
+# LED Support
+CONFIG_NEW_LEDS=y
+CONFIG_LEDS_CLASS=y
+CONFIG_LEDS_GPIO=y
+# LED Triggers
+CONFIG_LEDS_TRIGGERS=y
+CONFIG_LEDS_TRIGGER_TIMER=y
+CONFIG_LEDS_TRIGGER_IDE_DISK=y
+CONFIG_LEDS_TRIGGER_HEARTBEAT=y
+
+# Real Time Clock
+CONFIG_RTC_LIB=m
+CONFIG_RTC_CLASS=m
+
+### File systems
+CONFIG_EXT2_FS=m
+CONFIG_EXT3_FS=y
+CONFIG_EXT4_FS=y
+CONFIG_FUSE_FS=m
+# CD-ROM/DVD Filesystems
+CONFIG_ISO9660_FS=m
+CONFIG_JOLIET=y
+CONFIG_UDF_FS=m
+# DOS/FAT/NT Filesystems
+CONFIG_VFAT_FS=m
+# Pseudo filesystems
+CONFIG_PROC_FS=y
+CONFIG_SYSFS=y
+CONFIG_TMPFS=y
+# Miscellaneous filesystems
+CONFIG_MISC_FILESYSTEMS=y
+CONFIG_JFFS2_FS=m
+CONFIG_UBIFS_FS=m
+# Network File Systems
+CONFIG_NETWORK_FILESYSTEMS=y
+CONFIG_NFS_FS=y
+CONFIG_NFS_V3=y
+CONFIG_ROOT_NFS=y
+# Partition Types
+CONFIG_PARTITION_ADVANCED=y
+CONFIG_MSDOS_PARTITION=y
+# Native language support
+CONFIG_NLS=y
+CONFIG_NLS_CODEPAGE_437=m
+CONFIG_NLS_CODEPAGE_936=m
+CONFIG_NLS_ISO8859_1=m
+CONFIG_NLS_UTF8=m
+
+### Kernel hacking
+CONFIG_FRAME_WARN=8096
+CONFIG_MAGIC_SYSRQ=y
+CONFIG_DEBUG_KERNEL=y
+CONFIG_PROVE_LOCKING=n
+CONFIG_DEBUG_BUGVERBOSE=y
+CONFIG_FRAME_POINTER=y
+CONFIG_DEBUG_USER=y
+CONFIG_DEBUG_LL=y
+