Hello:
Currently running 2.2.18 with a Celeron 333 MHz and 1 256MB SDRAM
PC100 chip on the motherboard.
The MB will support up to a P-III 600 and 1GB of RAM using 256MB
Chips....I'm looking at going to the following in addition to the
existing RAM:
TWO - **256MB 32x64 PC100 Non-Parity Unbuf DIMM 3.3V SDRAM Standard
Simm/Flash Memory Card 168 Pin PC100 Unbuf 3.3V SDRAM
And a new CPU Intel Pentium III 600EB SECC2 rather than the Celeron.
Any problems with doing this or changes I need to make to the
kernal/system to optimize it??
George
===[George R. Kasica]=== +1 262 513 8503
President +1 206 374 6482 FAX
Netwrx Consulting Inc. Waukesha, WI USA
http://www.netwrx1.com
[email protected]
ICQ #12862186