This patch adds 6 help texts to arch/cris/drivers/Config.help.
The texts were obtained from ESR's v2.97 Configure.help.
Steven
--- linux-2.5.7-dj1/arch/cris/drivers/Config.help.orig Mon Mar 25 13:52:21 2002
+++ linux-2.5.7-dj1/arch/cris/drivers/Config.help Mon Mar 25 13:52:59 2002
@@ -572,3 +572,39 @@
CONFIG_ETRAX_PARALLEL_PORT1
Say Y here to enable parallel port 1.
+CONFIG_ETRAX_ETHERNET_LPSLAVE
+ This option enables a slave ETRAX 100 or ETRAX 100LX, connected to a
+ master ETRAX 100 or ETRAX 100LX through par0 and par1, to act as an
+ Ethernet controller.
+
+CONFIG_ETRAX_ETHERNET_LPSLAVE_HAS_LEDS
+ Enable if the slave has it's own LEDs.
+
+CONFIG_ETRAX_IDE
+ Enable this to get support for ATA/IDE. You can't use parallel
+ ports or SCSI ports at the same time.
+
+CONFIG_ETRAX_NETWORK_LED_ON_WHEN_ACTIVITY
+ Selecting LED_on_when_link will light the LED when there is a
+ connection and will flash off when there is activity.
+
+ Selecting LED_on_when_activity will light the LED only when
+ there is activity.
+
+ This setting will also affect the behaviour of other activity LEDs
+ e.g. Bluetooth.
+
+CONFIG_ETRAX_NETWORK_LED_ON_WHEN_LINK
+ Selecting LED_on_when_link will light the LED when there is a
+ connection and will flash off when there is activity.
+
+ Selecting LED_on_when_activity will light the LED only when
+ there is activity.
+
+ This setting will also affect the behaviour of other activity LEDs
+ e.g. Bluetooth.
+
+CONFIG_ETRAX_SERIAL_PORT0
+ Enables the ETRAX 100 serial driver for ser0 (ttyS0)
+ Normally you want this on, unless you use external DMA 1 that uses
+ the same DMA channels.