Hi all
Since test2-mm1 the kernel will not properly detect or enable my via
IDE-Controller. This is what I get:
VP_IDE: IDE controller at PCI slot 0000:00:11.1
VP_IDE: (ide_setup_pci_device:) Could not enable device.
2.6.0-test1-mm1 works though:
VP_IDE: IDE controller at PCI slot 0000:00:11.1
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
VP_IDE: VIA vt8235 (rev 00) IDE UDMA133 controller on pci0000:00:11.1
ide0: BM-DMA at 0xe800-0xe807, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xe808-0xe80f, BIOS settings: hdc:DMA, hdd:DMA
My box is a UP AMD 2700+. Kernel has IO-APIC enabled, but I am passing
the noapic kernel option at boot (cause else my USB is screwed up).
Any ideas?
--
Benjamin