While initializing the adm1021 device, the driver is performing a conversion
from fixed point to Celcius on values that were declaired as Celcius. On
my Dell Precision 220 this results in a shutdown after a couple of minutes
running.
This patch was made against the 2.6.0-test2 tree, and just removes the
conversion.
--rustyl
--- drivers/i2c/chips/adm1021.c.orig 2003-08-06 13:04:25.000000000 -0700
+++ drivers/i2c/chips/adm1021.c 2003-08-06 13:09:43.000000000 -0700
@@ -356,13 +356,13 @@
{
/* Initialize the adm1021 chip */
adm1021_write_value(client, ADM1021_REG_TOS_W,
- TEMP_TO_REG(adm1021_INIT_TOS));
+ adm1021_INIT_TOS);
adm1021_write_value(client, ADM1021_REG_THYST_W,
- TEMP_TO_REG(adm1021_INIT_THYST));
+ adm1021_INIT_THYST);
adm1021_write_value(client, ADM1021_REG_REMOTE_TOS_W,
- TEMP_TO_REG(adm1021_INIT_REMOTE_TOS));
+ adm1021_INIT_REMOTE_TOS);
adm1021_write_value(client, ADM1021_REG_REMOTE_THYST_W,
- TEMP_TO_REG(adm1021_INIT_REMOTE_THYST));
+ adm1021_INIT_REMOTE_THYST);
/* Enable ADC and disable suspend mode */
adm1021_write_value(client, ADM1021_REG_CONFIG_W, 0);
/* Set Conversion rate to 1/sec (this can be tinkered with) */