Hello, list.
I'm hoping someone here can shed some insight into just a weird issue I'm
having with 2.6.6-rc1 - or, if it's a bug, hoping the right person hears
about it so it can get fixed.
Note that I've been able to boot into other 2.6 kernels in the past, even
very recent ones, so it's something related to this specific version, I'm
convinced. I've not installed any new hardware, or done anything drastic
to the kernel config; in fact, I'm pretty sure the pertinent bits of the
kernel config are identical to the configs I used in older kernels, which
didn't cause the problem I'm outlining.
Anyway, here's my hardware:
Athlon-XP 2500
1024 MB DDR RAM
A7N8X 2.0
Onboard sound and ethernet
Geforce FX 5900
LSIU160 SCSI controller
Onboard SiI3112 SATA controller
WD Raptor 10K 70 GB HDD
Atlas 10K II SCSI HDD
Here's my issue:
I compiled 2.6.6-rc1, installed modules, updated the bootloader, then
rebooted... when I tried to load the new kernel, here's the screen output
I was able to record(I had to write it on paper, so couldn't get
everything; also, this might have some superficial inaccuracies)
sym0:<1010-33> rev 0x1 PCI 0000:01:0a.0 irq 16
sym0: using 64 bit DMA addressing
sym0: Symbios NVRAM ID7, fast 80, LVD, parity checking
sym0: Open drain IRQ driver, using on-chip SRAM
sym0: using LOAD/STORE based firmware
sym0: handling phase mismatch from SCRIPTS
sym0: scan at boot disabled for targets 0 1 2 3 4 5 6 7 8 9 10 11 12 13
14 15
sym0: scan for LUNS disabled for targets 0 1 2 3 4 5 6 7 8 9 10 11 12 13
14 15
scsi0: Sym-2.1.18j
Vendor: QUANTUM Model: ATLAS10K2-TY734J
Type: Direct-access ANSI SCSI revision: 03
scsi(0:0:0:0): Beginning Domain Validation
sym0:0:Wide asynchronous
sym0:0: ABORT operation started
sym0:0: ABORT operation timed out
sym0:0: DEVICE RESET operation started
sym0:0: DEVICE RESET operation completed
sym0: SCSI bus has been reset
sym0:0: ABORT operation started
sym0:0: ABORT operation timed out
sym0:0: DEVICE RESET operation started
sym0:0: DEVICE RESET operation completed
sym0: SCSI bus has been reset
After this, it just hangs for about three minutes, then the screen goes
blank, and the system remains unresponsive. Ctrl-Alt-Del does nothing. I
had to power off.
I was able to use the Gentoo 2.6.5 kernel just fine(aside from some
lockup bugs caused by an issue with my nForce2 motherboard - on that
subject, can anyone tell me if the patches remedying that have been
implimented?), and I have been able to use the 2.6.3 kernel as well, so
whatever changed is very recent, I am sure. Other people on the Gentoo
forums confirm this as an issue; I can prolly dig up links if necessary.
Attached are my kernel configs for the Gentoo 2.6.5-rc1 and vanilla
2.6.6-rc1 kernels, as well as the output from lspci, just in case that's
needed.
Thanks in advance for any help.