Use %p instead of %08x in printk().
Signed-off-by: Kulikov Vasiliy <[email protected]>
---
drivers/scsi/ultrastor.c | 12 ++++++------
1 files changed, 6 insertions(+), 6 deletions(-)
diff --git a/drivers/scsi/ultrastor.c b/drivers/scsi/ultrastor.c
index 27aa40f..4715b7c 100644
--- a/drivers/scsi/ultrastor.c
+++ b/drivers/scsi/ultrastor.c
@@ -1061,7 +1061,7 @@ static void ultrastor_interrupt(void *dev_id)
mscp = (struct mscp *)isa_bus_to_virt(inl(config.icm_address));
mscp_index = mscp - config.mscp;
if (mscp_index >= ULTRASTOR_MAX_CMDS) {
- printk("Ux4F interrupt: bad MSCP address %x\n", (unsigned int) mscp);
+ printk("Ux4F interrupt: bad MSCP address %p\n", mscp);
/* A command has been lost. Reset and report an error
for all commands. */
ultrastor_host_reset(dev_id);
@@ -1074,8 +1074,8 @@ static void ultrastor_interrupt(void *dev_id)
unsigned char icm_status = inb(config.icm_address - 1);
#if ULTRASTOR_DEBUG & (UD_INTERRUPT|UD_ERROR|UD_ABORT)
if (icm_status != 1 && icm_status != 2)
- printk("US24F: ICM status %x for MSCP %d (%x)\n", icm_status,
- mscp_index, (unsigned int) mscp);
+ printk("US24F: ICM status %x for MSCP %d (%p)\n", icm_status,
+ mscp_index, mscp);
#endif
/* The manual says clear interrupt then write 0 to ICM status.
This seems backwards, but I'll do it anyway. --jfc */
@@ -1104,7 +1104,7 @@ static void ultrastor_interrupt(void *dev_id)
if (!SCtmp)
{
#if ULTRASTOR_DEBUG & (UD_ABORT|UD_INTERRUPT)
- printk("MSCP %d (%x): no command\n", mscp_index, (unsigned int) mscp);
+ printk("MSCP %d (%p): no command\n", mscp_index, mscp);
#endif
#if ULTRASTOR_MAX_CMDS == 1
config.mscp_busy = FALSE;
@@ -1154,8 +1154,8 @@ static void ultrastor_interrupt(void *dev_id)
#if ULTRASTOR_DEBUG & (UD_ABORT|UD_INTERRUPT)
if (config.aborted[mscp_index])
- printk("Ux4 interrupt: MSCP %d (%x) aborted = %d\n",
- mscp_index, (unsigned int) mscp, config.aborted[mscp_index]);
+ printk("Ux4 interrupt: MSCP %d (%p) aborted = %d\n",
+ mscp_index, mscp, config.aborted[mscp_index]);
#endif
config.aborted[mscp_index] = 0;
--
1.7.0.4