Guo Ren (2):
irqchip: add C-SKY SMP interrupt controller
dt-bindings: interrupt-controller: C-SKY SMP intc
.../bindings/interrupt-controller/csky,mpintc.txt | 40 +++++
drivers/irqchip/Kconfig | 16 ++
drivers/irqchip/Makefile | 2 +
drivers/irqchip/irq-csky-mpintc.c | 196 +++++++++++++++++++++
4 files changed, 254 insertions(+)
create mode 100644 Documentation/devicetree/bindings/interrupt-controller/csky,mpintc.txt
create mode 100644 drivers/irqchip/irq-csky-mpintc.c
--
2.7.4
- irq-csky-mpintc is C-SKY smp system interrupt controller and it
could support 16 soft irqs, 16 private irqs, and 992 max common
irqs.
Changelog:
- remove irq_set_default_host() and use set_ipi_irq_mapping()
- change name with upstream feed-back
- change irq map, reserve soft_irq & private_irq space
- add License and Copyright
- support set_affinity for irq balance in SMP
Signed-off-by: Guo Ren <[email protected]>
---
drivers/irqchip/Kconfig | 16 ++++
drivers/irqchip/Makefile | 2 +
drivers/irqchip/irq-csky-mpintc.c | 196 ++++++++++++++++++++++++++++++++++++++
3 files changed, 214 insertions(+)
create mode 100644 drivers/irqchip/irq-csky-mpintc.c
diff --git a/drivers/irqchip/Kconfig b/drivers/irqchip/Kconfig
index 383e7b7..bf12549 100644
--- a/drivers/irqchip/Kconfig
+++ b/drivers/irqchip/Kconfig
@@ -371,6 +371,22 @@ config QCOM_PDC
Power Domain Controller driver to manage and configure wakeup
IRQs for Qualcomm Technologies Inc (QTI) mobile chips.
+config CSKY_MPINTC
+ bool "C-SKY Multi Processor Interrupt Controller"
+ depends on CSKY
+ help
+ Say yes here to enable C-SKY SMP interrupt controller driver used
+ for C-SKY SMP system. In fact it's not mmio map and it use ld/st
+ to visit the controller's register inside CPU.
+
+config CSKY_APB_INTC
+ bool "C-SKY APB Interrupt Controller"
+ depends on CSKY
+ help
+ Say yes here to enable C-SKY APB interrupt controller driver used
+ by C-SKY single core SOC system. It use mmio map apb-bus to visit
+ the controller's register.
+
endmenu
config SIFIVE_PLIC
diff --git a/drivers/irqchip/Makefile b/drivers/irqchip/Makefile
index fbd1ec8..72eaf53 100644
--- a/drivers/irqchip/Makefile
+++ b/drivers/irqchip/Makefile
@@ -87,4 +87,6 @@ obj-$(CONFIG_MESON_IRQ_GPIO) += irq-meson-gpio.o
obj-$(CONFIG_GOLDFISH_PIC) += irq-goldfish-pic.o
obj-$(CONFIG_NDS32) += irq-ativic32.o
obj-$(CONFIG_QCOM_PDC) += qcom-pdc.o
+obj-$(CONFIG_CSKY_MPINTC) += irq-csky-mpintc.o
+obj-$(CONFIG_CSKY_APB_INTC) += irq-csky-apb-intc.o
obj-$(CONFIG_SIFIVE_PLIC) += irq-sifive-plic.o
diff --git a/drivers/irqchip/irq-csky-mpintc.c b/drivers/irqchip/irq-csky-mpintc.c
new file mode 100644
index 0000000..dfe976d
--- /dev/null
+++ b/drivers/irqchip/irq-csky-mpintc.c
@@ -0,0 +1,196 @@
+// SPDX-License-Identifier: GPL-2.0
+// Copyright (C) 2018 Hangzhou C-SKY Microsystems co.,ltd.
+
+#include <linux/kernel.h>
+#include <linux/init.h>
+#include <linux/of.h>
+#include <linux/of_address.h>
+#include <linux/module.h>
+#include <linux/irqdomain.h>
+#include <linux/irqchip.h>
+#include <linux/irq.h>
+#include <linux/interrupt.h>
+#include <asm/irq.h>
+#include <asm/io.h>
+#include <asm/traps.h>
+#include <asm/reg_ops.h>
+#include <asm/smp.h>
+
+static struct irq_domain *root_domain;
+static void __iomem *INTCG_base;
+static void __iomem *INTCL_base;
+
+#define COMM_IRQ_BASE 32
+
+#define INTCG_SIZE 0x8000
+#define INTCL_SIZE 0x1000
+#define INTC_SIZE INTCL_SIZE*nr_cpu_ids + INTCG_SIZE
+
+#define INTCG_ICTLR 0x0
+#define INTCG_CICFGR 0x100
+#define INTCG_CIDSTR 0x1000
+
+#define INTCL_PICTLR 0x0
+#define INTCL_SIGR 0x60
+#define INTCL_HPPIR 0x68
+#define INTCL_RDYIR 0x6c
+#define INTCL_SENR 0xa0
+#define INTCL_CENR 0xa4
+#define INTCL_CACR 0xb4
+
+#define INTC_IRQS 256
+
+static DEFINE_PER_CPU(void __iomem *, intcl_reg);
+
+static void csky_mpintc_handler(struct pt_regs *regs)
+{
+ void __iomem *reg_base = this_cpu_read(intcl_reg);
+
+ do {
+ handle_domain_irq(root_domain,
+ readl_relaxed(reg_base + INTCL_RDYIR),
+ regs);
+ } while (readl_relaxed(reg_base + INTCL_HPPIR) & BIT(31));
+}
+
+static void csky_mpintc_enable(struct irq_data *d)
+{
+ void __iomem *reg_base = this_cpu_read(intcl_reg);
+
+ writel_relaxed(d->hwirq, reg_base + INTCL_SENR);
+}
+
+static void csky_mpintc_disable(struct irq_data *d)
+{
+ void __iomem *reg_base = this_cpu_read(intcl_reg);
+
+ writel_relaxed(d->hwirq, reg_base + INTCL_CENR);
+}
+
+static void csky_mpintc_eoi(struct irq_data *d)
+{
+ void __iomem *reg_base = this_cpu_read(intcl_reg);
+
+ writel_relaxed(d->hwirq, reg_base + INTCL_CACR);
+}
+
+#ifdef CONFIG_SMP
+static int csky_irq_set_affinity(struct irq_data *d,
+ const struct cpumask *mask_val,
+ bool force)
+{
+ unsigned int cpu;
+ unsigned int offset = 4 * (d->hwirq - COMM_IRQ_BASE);
+
+ if (!force)
+ cpu = cpumask_any_and(mask_val, cpu_online_mask);
+ else
+ cpu = cpumask_first(mask_val);
+
+ if (cpu >= nr_cpu_ids)
+ return -EINVAL;
+
+ /* Enable interrupt destination */
+ cpu |= BIT(31);
+
+ writel_relaxed(cpu, INTCG_base + INTCG_CIDSTR + offset);
+
+ irq_data_update_effective_affinity(d, cpumask_of(cpu));
+
+ return IRQ_SET_MASK_OK_DONE;
+}
+#endif
+
+static struct irq_chip csky_irq_chip = {
+ .name = "C-SKY SMP Intc",
+ .irq_eoi = csky_mpintc_eoi,
+ .irq_enable = csky_mpintc_enable,
+ .irq_disable = csky_mpintc_disable,
+#ifdef CONFIG_SMP
+ .irq_set_affinity = csky_irq_set_affinity,
+#endif
+};
+
+static int csky_irqdomain_map(struct irq_domain *d, unsigned int irq,
+ irq_hw_number_t hwirq)
+{
+ if(hwirq < COMM_IRQ_BASE) {
+ irq_set_percpu_devid(irq);
+ irq_set_chip_and_handler(irq, &csky_irq_chip, handle_percpu_irq);
+ } else {
+ irq_set_chip_and_handler(irq, &csky_irq_chip, handle_fasteoi_irq);
+ }
+
+ return 0;
+}
+
+static const struct irq_domain_ops csky_irqdomain_ops = {
+ .map = csky_irqdomain_map,
+ .xlate = irq_domain_xlate_onecell,
+};
+
+#ifdef CONFIG_SMP
+static void csky_mpintc_send_ipi(const unsigned long *mask, unsigned long irq)
+{
+ void __iomem *reg_base = this_cpu_read(intcl_reg);
+
+ /*
+ * INTCL_SIGR[3:0] INTID
+ * INTCL_SIGR[8:15] CPUMASK
+ */
+ writel_relaxed((*mask) << 8 | irq, reg_base + INTCL_SIGR);
+}
+
+static int csky_mpintc_ipi_irq_mapping(void)
+{
+ return irq_create_mapping(root_domain, IPI_IRQ);
+}
+#endif
+
+/* C-SKY multi processor interrupt controller */
+static int __init
+csky_mpintc_init(struct device_node *node, struct device_node *parent)
+{
+ unsigned int cpu, nr_irq;
+ int ret;
+
+ if (parent)
+ return 0;
+
+ ret = of_property_read_u32(node, "csky,num-irqs", &nr_irq);
+ if (ret < 0)
+ nr_irq = INTC_IRQS;
+
+ if (INTCG_base == NULL) {
+ INTCG_base = ioremap(mfcr("cr<31, 14>"), INTC_SIZE);
+ if (INTCG_base == NULL)
+ return -EIO;
+
+ INTCL_base = INTCG_base + INTCG_SIZE;
+
+ writel_relaxed(BIT(0), INTCG_base + INTCG_ICTLR);
+ }
+
+ root_domain = irq_domain_add_linear(node, nr_irq, &csky_irqdomain_ops,
+ NULL);
+ if (!root_domain)
+ return -ENXIO;
+
+ /* for every cpu */
+ for_each_present_cpu(cpu) {
+ per_cpu(intcl_reg, cpu) = INTCL_base + (INTCL_SIZE * cpu);
+ writel_relaxed(BIT(0), per_cpu(intcl_reg, cpu) + INTCL_PICTLR);
+ }
+
+ set_handle_irq(&csky_mpintc_handler);
+
+#ifdef CONFIG_SMP
+ set_send_ipi(&csky_mpintc_send_ipi);
+
+ set_ipi_irq_mapping(&csky_mpintc_ipi_irq_mapping);
+#endif
+
+ return 0;
+}
+IRQCHIP_DECLARE(csky_mpintc, "csky,mpintc", csky_mpintc_init);
+
--
2.7.4
- Dt-bindings doc about C-SKY Multi-processors interrupt controller.
Signed-off-by: Guo Ren <[email protected]>
---
.../bindings/interrupt-controller/csky,mpintc.txt | 40 ++++++++++++++++++++++
1 file changed, 40 insertions(+)
create mode 100644 Documentation/devicetree/bindings/interrupt-controller/csky,mpintc.txt
diff --git a/Documentation/devicetree/bindings/interrupt-controller/csky,mpintc.txt b/Documentation/devicetree/bindings/interrupt-controller/csky,mpintc.txt
new file mode 100644
index 0000000..49d1658
--- /dev/null
+++ b/Documentation/devicetree/bindings/interrupt-controller/csky,mpintc.txt
@@ -0,0 +1,40 @@
+===========================================
+C-SKY Multi-processors Interrupt Controller
+===========================================
+
+C-SKY Multi-processors Interrupt Controller is designed for ck807/ck810/ck860
+SMP soc, and it also could be used in non-SMP system.
+
+Interrupt number definition:
+
+ 0-15 : software irq, and we use 15 as our IPI_IRQ.
+ 16-31 : private irq, and we use 16 as the co-processor timer.
+ 31-1024: common irq for soc ip.
+
+=============================
+intc node bindings definition
+=============================
+
+ Description: Describes SMP interrupt controller
+
+ PROPERTIES
+
+ - compatible
+ Usage: required
+ Value type: <string>
+ Definition: must be "csky,mpintc"
+ - interrupt-cells
+ Usage: required
+ Value type: <u32>
+ Definition: must be <1>
+ - interrupt-controller:
+ Usage: required
+
+Examples:
+---------
+
+ intc: interrupt-controller {
+ compatible = "csky,mpintc";
+ #interrupt-cells = <1>;
+ interrupt-controller;
+ };
--
2.7.4