From: Etienne Carriere <[email protected]>
ux500 machines performs pins (GPIO) reconfiguration when entering
in the suspended mode. This reconfiguration aims at reaching an ultra
low power HW configuration.
Due to this HW reconfiguration, some HW devices can change of HW state
and have their output signals at level that could generate IRQs.
If the non-wakeup IRQs are disabled but not yet masked (delayed interrupt
disable feature from the generic irq layer), effective interrupts reach
the system only because the system attempt to enter the suspended mode.
To prevent such IRQs to trig, all irq chips embedded in ux500 platform
should enable their IRQCHIP_MASK_ON_SUSPEND flag.
Cc: Samuel Ortiz <[email protected]>
Signed-off-by: Etienne Carriere <[email protected]>
Signed-off-by: Linus Walleij <[email protected]>
---
drivers/mfd/db8500-prcmu.c | 1 +
1 file changed, 1 insertion(+)
diff --git a/drivers/mfd/db8500-prcmu.c b/drivers/mfd/db8500-prcmu.c
index 7040a00..25d2e9d 100644
--- a/drivers/mfd/db8500-prcmu.c
+++ b/drivers/mfd/db8500-prcmu.c
@@ -2615,6 +2615,7 @@ static struct irq_chip prcmu_irq_chip = {
.irq_ack = noop,
.irq_mask = prcmu_irq_mask,
.irq_unmask = prcmu_irq_unmask,
+ .flags = IRQCHIP_MASK_ON_SUSPEND,
};
static char *fw_project_name(u8 project)
--
1.7.11.3
On Wed, Aug 22, 2012 at 10:44 AM, Linus Walleij
<[email protected]> wrote:
> ux500 machines performs pins (GPIO) reconfiguration when entering
> in the suspended mode. This reconfiguration aims at reaching an ultra
> low power HW configuration.
Sam, please disregard this patch.
Yours,
Linus Walleij