Signed-off-by: LABBE Corentin <[email protected]>
---
drivers/hwmon/abituguru.c | 6 +++---
drivers/hwmon/abituguru3.c | 2 +-
drivers/hwmon/asus_atk0110.c | 2 +-
drivers/hwmon/max6650.c | 2 +-
drivers/hwmon/pmbus/pmbus_core.c | 2 +-
drivers/hwmon/w83791d.c | 2 +-
drivers/hwmon/w83792d.c | 2 +-
drivers/hwmon/w83793.c | 2 +-
8 files changed, 10 insertions(+), 10 deletions(-)
diff --git a/drivers/hwmon/abituguru.c b/drivers/hwmon/abituguru.c
index 2ebd6ce..9c8a6ba 100644
--- a/drivers/hwmon/abituguru.c
+++ b/drivers/hwmon/abituguru.c
@@ -164,7 +164,7 @@ static const u8 abituguru_bank2_max_threshold = 50;
static const int abituguru_pwm_settings_multiplier[5] = { 0, 1, 1, 1000, 1000 };
/*
* Min / Max allowed values for pwm_settings. Note: pwm1 (CPU fan) is a
- * special case the minium allowed pwm% setting for this is 30% (77) on
+ * special case the minimum allowed pwm% setting for this is 30% (77) on
* some MB's this special case is handled in the code!
*/
static const u8 abituguru_pwm_min[5] = { 0, 170, 170, 25, 25 };
@@ -517,7 +517,7 @@ abituguru_detect_bank1_sensor_type(struct abituguru_data *data,
ABIT_UGURU_DEBUG(2, "testing bank1 sensor %d\n", (int)sensor_addr);
/*
- * Volt sensor test, enable volt low alarm, set min value ridicously
+ * Volt sensor test, enable volt low alarm, set min value ridiculously
* high, or vica versa if the reading is very high. If its a volt
* sensor this should always give us an alarm.
*/
@@ -564,7 +564,7 @@ abituguru_detect_bank1_sensor_type(struct abituguru_data *data,
/*
* Temp sensor test, enable sensor as a temp sensor, set beep value
- * ridicously low (but not too low, otherwise uguru ignores it).
+ * ridiculously low (but not too low, otherwise uguru ignores it).
* If its a temp sensor this should always give us an alarm.
*/
buf[0] = ABIT_UGURU_TEMP_HIGH_ALARM_ENABLE;
diff --git a/drivers/hwmon/abituguru3.c b/drivers/hwmon/abituguru3.c
index 0cac8c0..4ae74aa8 100644
--- a/drivers/hwmon/abituguru3.c
+++ b/drivers/hwmon/abituguru3.c
@@ -176,7 +176,7 @@ struct abituguru3_data {
/*
* The abituguru3 supports up to 48 sensors, and thus has registers
- * sets for 48 sensors, for convienence reasons / simplicity of the
+ * sets for 48 sensors, for convenience reasons / simplicity of the
* code we always read and store all registers for all 48 sensors
*/
diff --git a/drivers/hwmon/asus_atk0110.c b/drivers/hwmon/asus_atk0110.c
index b25c643..1d7ff46 100644
--- a/drivers/hwmon/asus_atk0110.c
+++ b/drivers/hwmon/asus_atk0110.c
@@ -119,7 +119,7 @@ struct atk_data {
acpi_handle rtmp_handle;
acpi_handle rvlt_handle;
acpi_handle rfan_handle;
- /* new inteface */
+ /* new interface */
acpi_handle enumerate_handle;
acpi_handle read_handle;
acpi_handle write_handle;
diff --git a/drivers/hwmon/max6650.c b/drivers/hwmon/max6650.c
index 3c16cbd..0cafc39 100644
--- a/drivers/hwmon/max6650.c
+++ b/drivers/hwmon/max6650.c
@@ -660,7 +660,7 @@ static int max6650_init_client(struct i2c_client *client)
/*
* If mode is set to "full off", we change it to "open loop" and
* set DAC to 255, which has the same effect. We do this because
- * there's no "full off" mode defined in hwmon specifcations.
+ * there's no "full off" mode defined in hwmon specifications.
*/
if ((config & MAX6650_CFG_MODE_MASK) == MAX6650_CFG_MODE_OFF) {
diff --git a/drivers/hwmon/pmbus/pmbus_core.c b/drivers/hwmon/pmbus/pmbus_core.c
index 9319fcf..264d093 100644
--- a/drivers/hwmon/pmbus/pmbus_core.c
+++ b/drivers/hwmon/pmbus/pmbus_core.c
@@ -156,7 +156,7 @@ EXPORT_SYMBOL_GPL(pmbus_write_byte);
/*
* _pmbus_write_byte() is similar to pmbus_write_byte(), but checks if
- * a device specific mapping funcion exists and calls it if necessary.
+ * a device specific mapping function exists and calls it if necessary.
*/
static int _pmbus_write_byte(struct i2c_client *client, int page, u8 value)
{
diff --git a/drivers/hwmon/w83791d.c b/drivers/hwmon/w83791d.c
index a3feee3..bdcf2dc 100644
--- a/drivers/hwmon/w83791d.c
+++ b/drivers/hwmon/w83791d.c
@@ -1043,7 +1043,7 @@ static struct sensor_device_attribute sda_temp_alarm[] = {
SENSOR_ATTR(temp3_alarm, S_IRUGO, show_alarm, NULL, 13),
};
-/* get reatime status of all sensors items: voltage, temp, fan */
+/* get realtime status of all sensors items: voltage, temp, fan */
static ssize_t show_alarms_reg(struct device *dev,
struct device_attribute *attr, char *buf)
{
diff --git a/drivers/hwmon/w83792d.c b/drivers/hwmon/w83792d.c
index 5febb43..df58580 100644
--- a/drivers/hwmon/w83792d.c
+++ b/drivers/hwmon/w83792d.c
@@ -579,7 +579,7 @@ static ssize_t store_temp23(struct device *dev, struct device_attribute *attr,
return count;
}
-/* get reatime status of all sensors items: voltage, temp, fan */
+/* get realtime status of all sensors items: voltage, temp, fan */
static ssize_t
show_alarms_reg(struct device *dev, struct device_attribute *attr, char *buf)
{
diff --git a/drivers/hwmon/w83793.c b/drivers/hwmon/w83793.c
index b0c30a5..b6470ec 100644
--- a/drivers/hwmon/w83793.c
+++ b/drivers/hwmon/w83793.c
@@ -808,7 +808,7 @@ show_sf_ctrl(struct device *dev, struct device_attribute *attr, char *buf)
if (nr == TEMP_FAN_MAP) {
val = data->temp_fan_map[index];
} else if (nr == TEMP_PWM_ENABLE) {
- /* +2 to transfrom into 2 and 3 to conform with sysfs intf */
+ /* +2 to transform into 2 and 3 to conform with sysfs intf */
val = ((data->pwm_enable >> index) & 0x01) + 2;
} else if (nr == TEMP_CRUISE) {
val = TEMP_FROM_REG(data->temp_cruise[index] & 0x7f);
--
1.8.1.5
On Fri, Sep 27, 2013 at 02:36:04PM +0200, LABBE Corentin wrote:
>
> Signed-off-by: LABBE Corentin <[email protected]>
Applied to -next.
Thanks,
Guenter