From: Rameshwar Prasad Sahu <[email protected]>
The Arason SD host controller supports set block count command (cmd23)
and high speed mode. This patch re-enable both of these features that
was disabled. For device that doesn't support high speed, it should
configure its capability register accordingly instead disables it
explicitly.
Signed-off-by: Rameshwar Prasad Sahu <[email protected]>
---
drivers/mmc/host/sdhci-of-arasan.c | 5 -----
1 files changed, 0 insertions(+), 5 deletions(-)
diff --git a/drivers/mmc/host/sdhci-of-arasan.c b/drivers/mmc/host/sdhci-of-arasan.c
index 75379cb..5d9fdb3 100644
--- a/drivers/mmc/host/sdhci-of-arasan.c
+++ b/drivers/mmc/host/sdhci-of-arasan.c
@@ -172,11 +172,6 @@ static int sdhci_arasan_probe(struct platform_device *pdev)
goto clk_disable_all;
}
- if (of_device_is_compatible(pdev->dev.of_node, "arasan,sdhci-4.9a")) {
- host->quirks |= SDHCI_QUIRK_NO_HISPD_BIT;
- host->quirks2 |= SDHCI_QUIRK2_HOST_NO_CMD23;
- }
-
sdhci_get_of_property(pdev);
pltfm_host = sdhci_priv(host);
pltfm_host->priv = sdhci_arasan;
--
1.7.1