This commit enables the active pullup (APU bit) by default for
the DS2482 1-Wire master.
>From the DS2482 datasheet:
"The APU bit controls whether an active pullup (controlled slew-rate
transistor) or a passive pullup (Rwpu resistor) will be used to drive
a 1-Wire line from low to high. When APU = 0, active pullup is disabled
(resistor mode). Active Pullup should always be selected unless there is
only a single slave on the 1-Wire line."
According to the module author, Ben Gardner:
"It doesn't look like active pullup would cause any hurt if there
is only a single slave."
And my tests with multiple and single slaves on 1-Wire bus
confirms that.
This active pullup can be manually disabled using the introduced
module parameter:
active_pullup = 0
---
drivers/w1/masters/ds2482.c | 18 ++++++++++++++++++
1 file changed, 18 insertions(+)
diff --git a/drivers/w1/masters/ds2482.c b/drivers/w1/masters/ds2482.c
index b05e8fe..2e30db1 100644
--- a/drivers/w1/masters/ds2482.c
+++ b/drivers/w1/masters/ds2482.c
@@ -24,6 +24,19 @@
#include "../w1_int.h"
/**
+ * Allow the active pullup to be disabled, default is enabled.
+ *
+ * Note from the DS2482 datasheet:
+ * The APU bit controls whether an active pullup (controlled slew-rate
+ * transistor) or a passive pullup (Rwpu resistor) will be used to drive
+ * a 1-Wire line from low to high. When APU = 0, active pullup is disabled
+ * (resistor mode). Active Pullup should always be selected unless there is
+ * only a single slave on the 1-Wire line.
+ */
+static int ds2482_active_pullup = 1;
+module_param_named(active_pullup, ds2482_active_pullup, int, 0644);
+
+/**
* The DS2482 registers - there are 3 registers that are addressed by a read
* pointer. The read pointer is set by the last command executed.
*
@@ -138,6 +151,9 @@ struct ds2482_data {
*/
static inline u8 ds2482_calculate_config(u8 conf)
{
+ if (ds2482_active_pullup)
+ conf |= DS2482_REG_CFG_APU;
+
return conf | ((~conf & 0x0f) << 4);
}
@@ -546,6 +562,8 @@ static int ds2482_remove(struct i2c_client *client)
module_i2c_driver(ds2482_driver);
+MODULE_PARM_DESC(active_pullup, "Active pullup (apply to all buses): " \
+ "0-disable, 1-enable (default)");
MODULE_AUTHOR("Ben Gardner <[email protected]>");
MODULE_DESCRIPTION("DS2482 driver");
MODULE_LICENSE("GPL");
--
2.8.0.rc3