We used to use a fixed rate clock for the UARTs. Now that we have clock
support we can associate the correct clocks to the UARTs and drop the
26MHz fixed rate UART clock.
Signed-off-by: Erin Lo <[email protected]>
---
This patch dependents on "Add clock support for Mediatek MT2701"[1].
If we have clock support, we must associate the correct clocks to the UARTs.
Otherwise it will cause booting issue.
Please also accept this patch together with [1].
[1]http://lists.infradead.org/pipermail/linux-mediatek/2016-April/004938.html
---
arch/arm/boot/dts/mt2701.dtsi | 18 ++++++++----------
1 file changed, 8 insertions(+), 10 deletions(-)
diff --git a/arch/arm/boot/dts/mt2701.dtsi b/arch/arm/boot/dts/mt2701.dtsi
index 171d4da..e79e88f 100644
--- a/arch/arm/boot/dts/mt2701.dtsi
+++ b/arch/arm/boot/dts/mt2701.dtsi
@@ -71,12 +71,6 @@
#clock-cells = <0>;
};
- uart_clk: dummy26m {
- compatible = "fixed-clock";
- clock-frequency = <26000000>;
- #clock-cells = <0>;
- };
-
clk26m: oscillator@0 {
compatible = "fixed-clock";
#clock-cells = <0>;
@@ -167,7 +161,8 @@
"mediatek,mt6577-uart";
reg = <0 0x11002000 0 0x400>;
interrupts = <GIC_SPI 51 IRQ_TYPE_LEVEL_LOW>;
- clocks = <&uart_clk>;
+ clocks = <&pericfg CLK_PERI_UART0_SEL>, <&pericfg CLK_PERI_UART0>;
+ clock-names = "baud", "bus";
status = "disabled";
};
@@ -176,7 +171,8 @@
"mediatek,mt6577-uart";
reg = <0 0x11003000 0 0x400>;
interrupts = <GIC_SPI 52 IRQ_TYPE_LEVEL_LOW>;
- clocks = <&uart_clk>;
+ clocks = <&pericfg CLK_PERI_UART1_SEL>, <&pericfg CLK_PERI_UART1>;
+ clock-names = "baud", "bus";
status = "disabled";
};
@@ -185,7 +181,8 @@
"mediatek,mt6577-uart";
reg = <0 0x11004000 0 0x400>;
interrupts = <GIC_SPI 53 IRQ_TYPE_LEVEL_LOW>;
- clocks = <&uart_clk>;
+ clocks = <&pericfg CLK_PERI_UART2_SEL>, <&pericfg CLK_PERI_UART2>;
+ clock-names = "baud", "bus";
status = "disabled";
};
@@ -194,7 +191,8 @@
"mediatek,mt6577-uart";
reg = <0 0x11005000 0 0x400>;
interrupts = <GIC_SPI 54 IRQ_TYPE_LEVEL_LOW>;
- clocks = <&uart_clk>;
+ clocks = <&pericfg CLK_PERI_UART3_SEL>, <&pericfg CLK_PERI_UART3>;
+ clock-names = "baud", "bus";
status = "disabled";
};
};
--
1.9.1