From: Niklas Cassel <[email protected]>
phy_device->supported is originally set by the PHY driver.
The ethernet driver should filter phy_device->supported to only contain
flags supported by the IP.
The IP supports setting rx and tx flow control independently,
therefore SUPPORTED_Pause and SUPPORTED_Asym_Pause should not be cleared.
If the flags are cleared, pause frames cannot be enabled (even if they
are supported by the PHY).
Signed-off-by: Niklas Cassel <[email protected]>
Signed-off-by: Lars Persson <[email protected]>
---
drivers/net/ethernet/synopsys/dwc_eth_qos.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/drivers/net/ethernet/synopsys/dwc_eth_qos.c b/drivers/net/ethernet/synopsys/dwc_eth_qos.c
index c9891eac9775..93a3a919f723 100644
--- a/drivers/net/ethernet/synopsys/dwc_eth_qos.c
+++ b/drivers/net/ethernet/synopsys/dwc_eth_qos.c
@@ -985,7 +985,8 @@ static int dwceqos_mii_probe(struct net_device *ndev)
"phydev %p, phydev->phy_id 0xa%x, phydev->addr 0x%x\n",
phydev, phydev->phy_id, phydev->addr);
- phydev->supported &= PHY_GBIT_FEATURES;
+ phydev->supported &= PHY_GBIT_FEATURES | SUPPORTED_Pause |
+ SUPPORTED_Asym_Pause;
lp->link = 0;
lp->speed = 0;
--
2.1.4
From: Niklas Cassel <[email protected]>
Date: Mon, 17 Oct 2016 08:25:48 +0200
> From: Niklas Cassel <[email protected]>
>
> phy_device->supported is originally set by the PHY driver.
> The ethernet driver should filter phy_device->supported to only contain
> flags supported by the IP.
> The IP supports setting rx and tx flow control independently,
> therefore SUPPORTED_Pause and SUPPORTED_Asym_Pause should not be cleared.
> If the flags are cleared, pause frames cannot be enabled (even if they
> are supported by the PHY).
>
> Signed-off-by: Niklas Cassel <[email protected]>
> Signed-off-by: Lars Persson <[email protected]>
These two patches do not apply to the current 'net' tree, please respin.