Add resource type check for Fintek F81504/508/512, BAR3/4/5 must be
IORESOURCE_IO.
Fintek is trying to make F81504/508/512 works on MMIO interface, but
it's still in progress. We found some issue when the experiment IC
when the BAR3/4/5 is IORESOURCE_MEM. It'll cause wrong operation with
IO resource. So we'll add the resource check for this.
Signed-off-by: Ji-Ze Hong (Peter Hong) <[email protected]>
---
drivers/tty/serial/8250/8250_pci.c | 13 +++++++++----
1 file changed, 9 insertions(+), 4 deletions(-)
diff --git a/drivers/tty/serial/8250/8250_pci.c b/drivers/tty/serial/8250/8250_pci.c
index aa0166b..29198b9 100644
--- a/drivers/tty/serial/8250/8250_pci.c
+++ b/drivers/tty/serial/8250/8250_pci.c
@@ -1477,11 +1477,16 @@ static int pci_fintek_init(struct pci_dev *dev)
{
unsigned long iobase;
u32 max_port, i;
- u32 bar_data[3];
+ resource_size_t bar_data[3];
u8 config_base;
struct serial_private *priv = pci_get_drvdata(dev);
struct uart_8250_port *port;
+ if (!(pci_resource_flags(dev, 5) & IORESOURCE_IO) ||
+ !(pci_resource_flags(dev, 4) & IORESOURCE_IO) ||
+ !(pci_resource_flags(dev, 3) & IORESOURCE_IO))
+ return -ENODEV;
+
switch (dev->device) {
case 0x1104: /* 4 ports */
case 0x1108: /* 8 ports */
@@ -1495,9 +1500,9 @@ static int pci_fintek_init(struct pci_dev *dev)
}
/* Get the io address dispatch from the BIOS */
- pci_read_config_dword(dev, 0x24, &bar_data[0]);
- pci_read_config_dword(dev, 0x20, &bar_data[1]);
- pci_read_config_dword(dev, 0x1c, &bar_data[2]);
+ bar_data[0] = pci_resource_start(dev, 5);
+ bar_data[1] = pci_resource_start(dev, 4);
+ bar_data[2] = pci_resource_start(dev, 3);
for (i = 0; i < max_port; ++i) {
/* UART0 configuration offset start from 0x40 */
--
1.9.1