The decon uses HW-TRIGGER, so TE interrupt is not necessary.
Therefore, remove the te-gpios property in the TM2 dts.
Signed-off-by: Hoegeun Kwon <[email protected]>
---
arch/arm64/boot/dts/exynos/exynos5433-tm2.dts | 1 -
1 file changed, 1 deletion(-)
diff --git a/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts b/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
index 3ff9527..23191eb 100644
--- a/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
+++ b/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
@@ -60,7 +60,6 @@
vci-supply = <&ldo28_reg>;
reset-gpios = <&gpg0 0 GPIO_ACTIVE_LOW>;
enable-gpios = <&gpf1 5 GPIO_ACTIVE_HIGH>;
- te-gpios = <&gpf1 3 GPIO_ACTIVE_HIGH>;
};
};
--
1.9.1
2017년 04월 25일 10:54에 Hoegeun Kwon 이(가) 쓴 글:
> The decon uses HW-TRIGGER, so TE interrupt is not necessary.
> Therefore, remove the te-gpios property in the TM2 dts.
>
> Signed-off-by: Hoegeun Kwon <[email protected]>
> ---
> arch/arm64/boot/dts/exynos/exynos5433-tm2.dts | 1 -
> 1 file changed, 1 deletion(-)
>
> diff --git a/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts b/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
> index 3ff9527..23191eb 100644
> --- a/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
> +++ b/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
> @@ -60,7 +60,6 @@
> vci-supply = <&ldo28_reg>;
> reset-gpios = <&gpg0 0 GPIO_ACTIVE_LOW>;
> enable-gpios = <&gpf1 5 GPIO_ACTIVE_HIGH>;
> - te-gpios = <&gpf1 3 GPIO_ACTIVE_HIGH>;
Reviewed-by: Inki Dae <[email protected]>
Thanks,
Inki Dae
> };
> };
>
>
On Tue, Apr 25, 2017 at 3:54 AM, Hoegeun Kwon <[email protected]> wrote:
> The decon uses HW-TRIGGER, so TE interrupt is not necessary.
> Therefore, remove the te-gpios property in the TM2 dts.
>
> Signed-off-by: Hoegeun Kwon <[email protected]>
> ---
> arch/arm64/boot/dts/exynos/exynos5433-tm2.dts | 1 -
> 1 file changed, 1 deletion(-)
>
Looks correct. It is too late for me for v4.12 so I will pick it up
for v4.13. For my reference:
Reviewed-by: Krzysztof Kozlowski <[email protected]>
Best regards,
Krzysztof