When using MII/GMII/SGMII in the Altera SoC, the phy needs to be
wired through the FPGA. To ensure correct behavior, the appropriate
bit in the System Manager FPGA Interface Group register needs to be
set.
Signed-off-by: Stephan Gatzka <[email protected]>
---
drivers/net/ethernet/stmicro/stmmac/dwmac-socfpga.c | 5 ++++-
1 file changed, 4 insertions(+), 1 deletion(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-socfpga.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-socfpga.c
index 17d4bba..6e35957 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-socfpga.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-socfpga.c
@@ -269,7 +269,10 @@ static int socfpga_dwmac_set_phy_mode(struct socfpga_dwmac *dwmac)
ctrl &= ~(SYSMGR_EMACGRP_CTRL_PHYSEL_MASK << reg_shift);
ctrl |= val << reg_shift;
- if (dwmac->f2h_ptp_ref_clk) {
+ if (dwmac->f2h_ptp_ref_clk ||
+ phymode == PHY_INTERFACE_MODE_MII ||
+ phymode == PHY_INTERFACE_MODE_GMII ||
+ phymode == PHY_INTERFACE_MODE_SGMII) {
ctrl |= SYSMGR_EMACGRP_CTRL_PTP_REF_CLK_MASK << (reg_shift / 2);
regmap_read(sys_mgr_base_addr, SYSMGR_FPGAGRP_MODULE_REG,
&module);
--
2.7.4
From: Stephan Gatzka <[email protected]>
Date: Tue, 22 Aug 2017 14:25:07 +0200
> When using MII/GMII/SGMII in the Altera SoC, the phy needs to be
> wired through the FPGA. To ensure correct behavior, the appropriate
> bit in the System Manager FPGA Interface Group register needs to be
> set.
>
> Signed-off-by: Stephan Gatzka <[email protected]>
Applied, thanks.