In xen_blkif_disconnect, before checking inflight I/O, following code
stops the blkback thread,
if (ring->xenblkd) {
kthread_stop(ring->xenblkd);
wake_up(&ring->shutdown_wq);
}
If there is inflight I/O in any non-last queue, blkback returns -EBUSY
directly, and above code would not be called to stop thread of remaining
queue and processs them. When removing vbd device with lots of disk I/O
load, some queues with inflight I/O still have blkback thread running even
though the corresponding vbd device or guest is gone.
And this could cause some problems, for example, if the backend device type
is file, some loop devices and blkback thread always lingers there forever
after guest is destroyed, and this causes failure of umounting repositories
unless rebooting the dom0.
This patch allows thread of every queue has the chance to get stopped.
Otherwise, only thread of queue previous to(including) first busy one get
stopped, blkthread of remaining queue will still run. So stop all threads
properly and return -EBUSY if any queue has inflight I/O.
Signed-off-by: Annie Li <[email protected]>
Reviewed-by: Herbert van den Bergh <[email protected]>
Reviewed-by: Bhavesh Davda <[email protected]>
Reviewed-by: Adnan Misherfi <[email protected]>
Acked-by: Roger Pau Monné <[email protected]>
---
v2: enhance patch description and add Acked-by
---
drivers/block/xen-blkback/xenbus.c | 10 ++++++++--
1 file changed, 8 insertions(+), 2 deletions(-)
diff --git a/drivers/block/xen-blkback/xenbus.c b/drivers/block/xen-blkback/xenbus.c
index 792da68..2adb859 100644
--- a/drivers/block/xen-blkback/xenbus.c
+++ b/drivers/block/xen-blkback/xenbus.c
@@ -244,6 +244,7 @@ static int xen_blkif_disconnect(struct xen_blkif *blkif)
{
struct pending_req *req, *n;
unsigned int j, r;
+ bool busy = false;
for (r = 0; r < blkif->nr_rings; r++) {
struct xen_blkif_ring *ring = &blkif->rings[r];
@@ -261,8 +262,10 @@ static int xen_blkif_disconnect(struct xen_blkif *blkif)
* don't have any discard_io or other_io requests. So, checking
* for inflight IO is enough.
*/
- if (atomic_read(&ring->inflight) > 0)
- return -EBUSY;
+ if (atomic_read(&ring->inflight) > 0) {
+ busy = true;
+ continue;
+ }
if (ring->irq) {
unbind_from_irqhandler(ring->irq, ring);
@@ -300,6 +303,9 @@ static int xen_blkif_disconnect(struct xen_blkif *blkif)
WARN_ON(i != (XEN_BLKIF_REQS_PER_PAGE * blkif->nr_ring_pages));
ring->active = false;
}
+ if (busy)
+ return -EBUSY;
+
blkif->nr_ring_pages = 0;
/*
* blkif->rings was allocated in connect_ring, so we should free it in
--
1.9.3