From: Honghui Zhang <[email protected]>
There maybe a same irq reentry scenario after irq received in current
irq handle flow:
EP device PCIe host driver EP driver
1. issue an irq
2. received irq
3. clear irq status
4. dispatch irq
5. clear irq source
The irq status was not successfully cleared at step 2 since the irq
source was not cleared yet. So the PCIe host driver may receive the
same irq after step 5. Then there's an irq reentry occurred.
Even worse, if the reentry irq was not an irq that EP driver expected,
it may not handle the irq. Then we may run into the dead loop from
step 2 to step 4.
Clear the irq status after irq have been dispatched to avoid the irq
reentry.
Signed-off-by: Honghui Zhang <[email protected]>
---
drivers/pci/host/pcie-mediatek.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/pci/host/pcie-mediatek.c b/drivers/pci/host/pcie-mediatek.c
index db93efd..3248771 100644
--- a/drivers/pci/host/pcie-mediatek.c
+++ b/drivers/pci/host/pcie-mediatek.c
@@ -605,11 +605,11 @@ static irqreturn_t mtk_pcie_intr_handler(int irq, void *data)
while ((status = readl(port->base + PCIE_INT_STATUS)) & INTX_MASK) {
for_each_set_bit_from(bit, &status, PCI_NUM_INTX + INTX_SHIFT) {
- /* Clear the INTx */
- writel(1 << bit, port->base + PCIE_INT_STATUS);
virq = irq_find_mapping(port->irq_domain,
bit - INTX_SHIFT);
generic_handle_irq(virq);
+ /* Clear the INTx */
+ writel(1 << bit, port->base + PCIE_INT_STATUS);
}
}
@@ -619,10 +619,10 @@ static irqreturn_t mtk_pcie_intr_handler(int irq, void *data)
while ((imsi_status = readl(port->base + PCIE_IMSI_STATUS))) {
for_each_set_bit(bit, &imsi_status, MTK_MSI_IRQS_NUM) {
- /* Clear the MSI */
- writel(1 << bit, port->base + PCIE_IMSI_STATUS);
virq = irq_find_mapping(port->msi_domain, bit);
generic_handle_irq(virq);
+ /* Clear the MSI */
+ writel(1 << bit, port->base + PCIE_IMSI_STATUS);
}
}
/* Clear MSI interrupt status */
--
2.6.4
On Wed, 2017-12-20 at 10:52 +0800, [email protected] wrote:
> From: Honghui Zhang <[email protected]>
>
> There maybe a same irq reentry scenario after irq received in current
> irq handle flow:
> EP device PCIe host driver EP driver
> 1. issue an irq
> 2. received irq
> 3. clear irq status
> 4. dispatch irq
> 5. clear irq source
> The irq status was not successfully cleared at step 2 since the irq
> source was not cleared yet. So the PCIe host driver may receive the
> same irq after step 5. Then there's an irq reentry occurred.
> Even worse, if the reentry irq was not an irq that EP driver expected,
> it may not handle the irq. Then we may run into the dead loop from
> step 2 to step 4.
> Clear the irq status after irq have been dispatched to avoid the irq
> reentry.
>
> Signed-off-by: Honghui Zhang <[email protected]>
> ---
> drivers/pci/host/pcie-mediatek.c | 8 ++++----
> 1 file changed, 4 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/pci/host/pcie-mediatek.c b/drivers/pci/host/pcie-mediatek.c
> index db93efd..3248771 100644
> --- a/drivers/pci/host/pcie-mediatek.c
> +++ b/drivers/pci/host/pcie-mediatek.c
> @@ -605,11 +605,11 @@ static irqreturn_t mtk_pcie_intr_handler(int irq, void *data)
>
> while ((status = readl(port->base + PCIE_INT_STATUS)) & INTX_MASK) {
> for_each_set_bit_from(bit, &status, PCI_NUM_INTX + INTX_SHIFT) {
> - /* Clear the INTx */
> - writel(1 << bit, port->base + PCIE_INT_STATUS);
> virq = irq_find_mapping(port->irq_domain,
> bit - INTX_SHIFT);
> generic_handle_irq(virq);
> + /* Clear the INTx */
> + writel(1 << bit, port->base + PCIE_INT_STATUS);
> }
> }
>
> @@ -619,10 +619,10 @@ static irqreturn_t mtk_pcie_intr_handler(int irq, void *data)
>
> while ((imsi_status = readl(port->base + PCIE_IMSI_STATUS))) {
> for_each_set_bit(bit, &imsi_status, MTK_MSI_IRQS_NUM) {
> - /* Clear the MSI */
> - writel(1 << bit, port->base + PCIE_IMSI_STATUS);
> virq = irq_find_mapping(port->msi_domain, bit);
> generic_handle_irq(virq);
> + /* Clear the MSI */
> + writel(1 << bit, port->base + PCIE_IMSI_STATUS);
> }
> }
> /* Clear MSI interrupt status */
Acked-by: Ryder Lee <[email protected]>
Thanks.
[+cc Lorenzo, please cc him on all drivers/{host,dwc,endpoint} material]
Please run "git log --oneline drivers/pci/host/pcie-mediatek.c" and
make yours match. Same capitalization, same sentence structure, etc.,
e.g.,
PCI: mediatek: Clear IRQ status ...
s/dispathed/dispatched/
s/irq/IRQ/ in the summary and all the English text below.
On Wed, Dec 20, 2017 at 10:52:14AM +0800, [email protected] wrote:
> From: Honghui Zhang <[email protected]>
>
> There maybe a same irq reentry scenario after irq received in current
> irq handle flow:
> EP device PCIe host driver EP driver
> 1. issue an irq
> 2. received irq
> 3. clear irq status
> 4. dispatch irq
> 5. clear irq source
> The irq status was not successfully cleared at step 2 since the irq
> source was not cleared yet. So the PCIe host driver may receive the
> same irq after step 5. Then there's an irq reentry occurred.
> Even worse, if the reentry irq was not an irq that EP driver expected,
> it may not handle the irq. Then we may run into the dead loop from
By "dead loop" I assume you mean "infinite loop"? I don't think it's
a deadlock since nothing is waiting.
> step 2 to step 4.
> Clear the irq status after irq have been dispatched to avoid the irq
> reentry.
>
> Signed-off-by: Honghui Zhang <[email protected]>
> ---
> drivers/pci/host/pcie-mediatek.c | 8 ++++----
> 1 file changed, 4 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/pci/host/pcie-mediatek.c b/drivers/pci/host/pcie-mediatek.c
> index db93efd..3248771 100644
> --- a/drivers/pci/host/pcie-mediatek.c
> +++ b/drivers/pci/host/pcie-mediatek.c
> @@ -605,11 +605,11 @@ static irqreturn_t mtk_pcie_intr_handler(int irq, void *data)
>
> while ((status = readl(port->base + PCIE_INT_STATUS)) & INTX_MASK) {
> for_each_set_bit_from(bit, &status, PCI_NUM_INTX + INTX_SHIFT) {
> - /* Clear the INTx */
> - writel(1 << bit, port->base + PCIE_INT_STATUS);
> virq = irq_find_mapping(port->irq_domain,
> bit - INTX_SHIFT);
> generic_handle_irq(virq);
> + /* Clear the INTx */
> + writel(1 << bit, port->base + PCIE_INT_STATUS);
> }
> }
>
> @@ -619,10 +619,10 @@ static irqreturn_t mtk_pcie_intr_handler(int irq, void *data)
>
> while ((imsi_status = readl(port->base + PCIE_IMSI_STATUS))) {
> for_each_set_bit(bit, &imsi_status, MTK_MSI_IRQS_NUM) {
> - /* Clear the MSI */
> - writel(1 << bit, port->base + PCIE_IMSI_STATUS);
> virq = irq_find_mapping(port->msi_domain, bit);
> generic_handle_irq(virq);
> + /* Clear the MSI */
> + writel(1 << bit, port->base + PCIE_IMSI_STATUS);
> }
> }
> /* Clear MSI interrupt status */
> --
> 2.6.4
>
>
> _______________________________________________
> linux-arm-kernel mailing list
> [email protected]
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
On Wed, 2017-12-20 at 18:52 -0600, Bjorn Helgaas wrote:
> [+cc Lorenzo, please cc him on all drivers/{host,dwc,endpoint} material]
>
> Please run "git log --oneline drivers/pci/host/pcie-mediatek.c" and
> make yours match. Same capitalization, same sentence structure, etc.,
> e.g.,
>
> PCI: mediatek: Clear IRQ status ...
>
> s/dispathed/dispatched/
>
> s/irq/IRQ/ in the summary and all the English text below.
Thanks for your review and sorry for the mismatch, I will fix that in
next version.
>
> On Wed, Dec 20, 2017 at 10:52:14AM +0800, [email protected] wrote:
> > From: Honghui Zhang <[email protected]>
> >
> > There maybe a same irq reentry scenario after irq received in current
> > irq handle flow:
> > EP device PCIe host driver EP driver
> > 1. issue an irq
> > 2. received irq
> > 3. clear irq status
> > 4. dispatch irq
> > 5. clear irq source
> > The irq status was not successfully cleared at step 2 since the irq
> > source was not cleared yet. So the PCIe host driver may receive the
> > same irq after step 5. Then there's an irq reentry occurred.
> > Even worse, if the reentry irq was not an irq that EP driver expected,
> > it may not handle the irq. Then we may run into the dead loop from
>
> By "dead loop" I assume you mean "infinite loop"? I don't think it's
> a deadlock since nothing is waiting.
>
Yes, it should be "infinite loop", I will update the commit message in
next version.
thanks.
> > step 2 to step 4.
> > Clear the irq status after irq have been dispatched to avoid the irq
> > reentry.
> >
> > Signed-off-by: Honghui Zhang <[email protected]>
> > ---
> > drivers/pci/host/pcie-mediatek.c | 8 ++++----
> > 1 file changed, 4 insertions(+), 4 deletions(-)
> >
> > diff --git a/drivers/pci/host/pcie-mediatek.c b/drivers/pci/host/pcie-mediatek.c
> > index db93efd..3248771 100644
> > --- a/drivers/pci/host/pcie-mediatek.c
> > +++ b/drivers/pci/host/pcie-mediatek.c
> > @@ -605,11 +605,11 @@ static irqreturn_t mtk_pcie_intr_handler(int irq, void *data)
> >
> > while ((status = readl(port->base + PCIE_INT_STATUS)) & INTX_MASK) {
> > for_each_set_bit_from(bit, &status, PCI_NUM_INTX + INTX_SHIFT) {
> > - /* Clear the INTx */
> > - writel(1 << bit, port->base + PCIE_INT_STATUS);
> > virq = irq_find_mapping(port->irq_domain,
> > bit - INTX_SHIFT);
> > generic_handle_irq(virq);
> > + /* Clear the INTx */
> > + writel(1 << bit, port->base + PCIE_INT_STATUS);
> > }
> > }
> >
> > @@ -619,10 +619,10 @@ static irqreturn_t mtk_pcie_intr_handler(int irq, void *data)
> >
> > while ((imsi_status = readl(port->base + PCIE_IMSI_STATUS))) {
> > for_each_set_bit(bit, &imsi_status, MTK_MSI_IRQS_NUM) {
> > - /* Clear the MSI */
> > - writel(1 << bit, port->base + PCIE_IMSI_STATUS);
> > virq = irq_find_mapping(port->msi_domain, bit);
> > generic_handle_irq(virq);
> > + /* Clear the MSI */
> > + writel(1 << bit, port->base + PCIE_IMSI_STATUS);
> > }
> > }
> > /* Clear MSI interrupt status */
> > --
> > 2.6.4
> >
> >
> > _______________________________________________
> > linux-arm-kernel mailing list
> > [email protected]
> > http://lists.infradead.org/mailman/listinfo/linux-arm-kernel