2018-05-13 23:27:00

by Hernán Gonzalez

Subject: [PATCH] ARM: dts: vf-colibri-eval-v3.dtsi: Use IRQ_TYPE specifier

GPIO_ACTIVE_LOW was being used to specify an interrupt, use
IRQ_TYPE_EDGE_RISING instead. This improves DT readability.

Signed-off-by: Hernán Gonzalez <[email protected]>
---
arch/arm/boot/dts/vf-colibri-eval-v3.dtsi | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/vf-colibri-eval-v3.dtsi b/arch/arm/boot/dts/vf-colibri-eval-v3.dtsi
index d8b2972..e2da122 100644
--- a/arch/arm/boot/dts/vf-colibri-eval-v3.dtsi
+++ b/arch/arm/boot/dts/vf-colibri-eval-v3.dtsi
@@ -117,7 +117,7 @@
clocks = <&clk16m>;
spi-max-frequency = <10000000>;
interrupt-parent = <&gpio1>;
- interrupts = <11 GPIO_ACTIVE_LOW>;
+ interrupts = <11 IRQ_TYPE_EDGE_RISING>;
};
};

--
2.7.4

2018-05-15 07:12:56

by Shawn Guo

Subject: Re: [PATCH] ARM: dts: vf-colibri-eval-v3.dtsi: Use IRQ_TYPE specifier

On Sun, May 13, 2018 at 08:24:54PM -0300, Hern?n Gonzalez wrote:
> GPIO_ACTIVE_LOW was being used to specify an interrupt, use
> IRQ_TYPE_EDGE_RISING instead. This improves DT readability.
>
> Signed-off-by: Hern?n Gonzalez <[email protected]>

Applied, thanks.