i.MX8MN has different speed grade definition compared to
i.MX8MQ/i.MX8MM, when fuses are NOT written, the default
speed_grade should be set to minimum available OPP defined
in DT which is 1.2GHz, the corresponding speed_grade value
should be 0xb.
Fixes: 5b8010ba70d5 ("cpufreq: imx-cpufreq-dt: Add i.MX8MN support")
Signed-off-by: Anson Huang <[email protected]>
---
Changes since V1:
- Improve the coding style by removing the tab;
---
drivers/cpufreq/imx-cpufreq-dt.c | 20 ++++++++++----------
1 file changed, 10 insertions(+), 10 deletions(-)
diff --git a/drivers/cpufreq/imx-cpufreq-dt.c b/drivers/cpufreq/imx-cpufreq-dt.c
index 35db14c..85a6efd 100644
--- a/drivers/cpufreq/imx-cpufreq-dt.c
+++ b/drivers/cpufreq/imx-cpufreq-dt.c
@@ -44,19 +44,19 @@ static int imx_cpufreq_dt_probe(struct platform_device *pdev)
mkt_segment = (cell_value & OCOTP_CFG3_MKT_SEGMENT_MASK) >> OCOTP_CFG3_MKT_SEGMENT_SHIFT;
/*
- * Early samples without fuses written report "0 0" which means
- * consumer segment and minimum speed grading.
- *
- * According to datasheet minimum speed grading is not supported for
- * consumer parts so clamp to 1 to avoid warning for "no OPPs"
+ * Early samples without fuses written report "0 0" which may NOT
+ * match any OPP defined in DT. So clamp to minimum OPP defined in
+ * DT to avoid warning for "no OPPs".
*
* Applies to i.MX8M series SoCs.
*/
- if (mkt_segment == 0 && speed_grade == 0 && (
- of_machine_is_compatible("fsl,imx8mm") ||
- of_machine_is_compatible("fsl,imx8mn") ||
- of_machine_is_compatible("fsl,imx8mq")))
- speed_grade = 1;
+ if (mkt_segment == 0 && speed_grade == 0) {
+ if (of_machine_is_compatible("fsl,imx8mm") ||
+ of_machine_is_compatible("fsl,imx8mq"))
+ speed_grade = 1;
+ if (of_machine_is_compatible("fsl,imx8mn"))
+ speed_grade = 0xb;
+ }
supported_hw[0] = BIT(speed_grade);
supported_hw[1] = BIT(mkt_segment);
--
2.7.4