When supporting Rpi Camera v2 Module on the RZ/G2E, found the driver had
some issues with rcar mipi-csi driver. The sensor never entered into LP-11
state.
The powerup sequence in the datasheet[1] shows the sensor entering into
LP-11 in streaming mode, so to fix this issue transitions are performed
from "streaming -> standby" in the probe() after power up.
With this commit the sensor is able to enter LP-11 mode during power up,
as expected by some CSI-2 controllers.
[1] https://publiclab.org/system/images/photos/000/023/294/original/
RASPBERRY_PI_CAMERA_V2_DATASHEET_IMX219PQH5_7.0.0_Datasheet_XXX.PDF
Signed-off-by: Lad Prabhakar <[email protected]>
Acked-by: Dave Stevenson <[email protected]>
---
drivers/media/i2c/imx219.c | 17 +++++++++++++++++
1 file changed, 17 insertions(+)
diff --git a/drivers/media/i2c/imx219.c b/drivers/media/i2c/imx219.c
index f1effb5..16010ca 100644
--- a/drivers/media/i2c/imx219.c
+++ b/drivers/media/i2c/imx219.c
@@ -1224,6 +1224,23 @@ static int imx219_probe(struct i2c_client *client)
/* Set default mode to max resolution */
imx219->mode = &supported_modes[0];
+ /* sensor doesn't enter LP-11 state upon power up until and unless
+ * streaming is started, so upon power up switch the modes to:
+ * streaming -> standby
+ */
+ ret = imx219_write_reg(imx219, IMX219_REG_MODE_SELECT,
+ IMX219_REG_VALUE_08BIT, IMX219_MODE_STREAMING);
+ if (ret < 0)
+ goto error_power_off;
+ usleep_range(100, 110);
+
+ /* put sensor back to standby mode */
+ ret = imx219_write_reg(imx219, IMX219_REG_MODE_SELECT,
+ IMX219_REG_VALUE_08BIT, IMX219_MODE_STANDBY);
+ if (ret < 0)
+ goto error_power_off;
+ usleep_range(100, 110);
+
ret = imx219_init_controls(imx219);
if (ret)
goto error_power_off;
--
2.7.4