From: Richard Gong <[email protected]>
Add COMMAND_AUTHENTICATE_BITSTREAM command flag for new added bitstream
authentication feature. Authenticating a bitstream is to make sure a signed
bitstream has the valid signatures.
Except for the actual configuration of the device, the bitstream
authentication works the same way as FPGA configuration does. If the
authentication passes, the signed bitstream will be programmed into QSPI
flash memory and will be expected to boot without issues.
Signed-off-by: Richard Gong <[email protected]>
---
v4: remove change at COMMAND_RECONFIG_FLAG_PARTIAL flag & add that to a
separate commit 27ad5309c247b6bde8a098e17e9bd9b1576b7f71.
v3: no change
v2: new added
---
include/linux/firmware/intel/stratix10-svc-client.h | 5 +++++
1 file changed, 5 insertions(+)
diff --git a/include/linux/firmware/intel/stratix10-svc-client.h b/include/linux/firmware/intel/stratix10-svc-client.h
index f843c6a..fa9581d 100644
--- a/include/linux/firmware/intel/stratix10-svc-client.h
+++ b/include/linux/firmware/intel/stratix10-svc-client.h
@@ -55,8 +55,13 @@
*
* COMMAND_RECONFIG_FLAG_PARTIAL:
* Set to FPGA configuration type (full or partial).
+ *
+ * COMMAND_AUTHENTICATE_BITSTREAM:
+ * Set for bitstream authentication, which makes sure a signed bitstream
+ * has valid signatures before committing it to device.
*/
#define COMMAND_RECONFIG_FLAG_PARTIAL 0
+#define COMMAND_AUTHENTICATE_BITSTREAM 1
/**
* Timeout settings for service clients:
--
2.7.4