Add temp-alarm support for PM8350C pmic.
Signed-off-by: satya priya <[email protected]>
Reviewed-by: Matthias Kaehlcke <[email protected]>
---
Changes in RESEND V4:
- No Changes.
Changes in V5:
- Split this patch into two. One for adding temp-alarm support and
next one to correct GPIO node.
arch/arm64/boot/dts/qcom/pm8350c.dtsi | 29 +++++++++++++++++++++++++++++
1 file changed, 29 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/pm8350c.dtsi b/arch/arm64/boot/dts/qcom/pm8350c.dtsi
index 2b9b75e..f926508 100644
--- a/arch/arm64/boot/dts/qcom/pm8350c.dtsi
+++ b/arch/arm64/boot/dts/qcom/pm8350c.dtsi
@@ -13,6 +13,13 @@
#address-cells = <1>;
#size-cells = <0>;
+ pm8350c_temp_alarm: temp-alarm@a00 {
+ compatible = "qcom,spmi-temp-alarm";
+ reg = <0xa00>;
+ interrupts = <0x2 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
+ #thermal-sensor-cells = <0>;
+ };
+
pm8350c_gpios: gpio@8800 {
compatible = "qcom,pm8350c-gpio";
reg = <0x8800>;
@@ -23,3 +30,25 @@
};
};
};
+
+&thermal_zones {
+ pm8350c_thermal: pm8350c-thermal {
+ polling-delay-passive = <100>;
+ polling-delay = <0>;
+ thermal-sensors = <&pm8350c_temp_alarm>;
+
+ trips {
+ pm8350c_trip0: trip0 {
+ temperature = <95000>;
+ hysteresis = <0>;
+ type = "passive";
+ };
+
+ pm8350c_crit: pm8350c-crit {
+ temperature = <115000>;
+ hysteresis = <0>;
+ type = "critical";
+ };
+ };
+ };
+};
--
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member
of Code Aurora Forum, hosted by The Linux Foundation