From: Shravya Kumbham <[email protected]>
In xemaclite_open() function we are setting the max speed of
emaclite to 100Mb using phy_set_max_speed() function so,
there is no need to write the advertising registers to stop
giga-bit speed and the phy_start() function starts the
auto-negotiation so, there is no need to handle it separately
using advertising registers. Remove the phy_read and phy_write
of advertising registers in xemaclite_open() function.
Signed-off-by: Shravya Kumbham <[email protected]>
Signed-off-by: Radhey Shyam Pandey <[email protected]>
Reviewed-by: Andrew Lunn <[email protected]>
---
Changes for v3:
- None
Changes for v2:
- Added Andrew's Reviewed-by tag.
---
drivers/net/ethernet/xilinx/xilinx_emaclite.c | 15 ---------------
1 file changed, 15 deletions(-)
diff --git a/drivers/net/ethernet/xilinx/xilinx_emaclite.c b/drivers/net/ethernet/xilinx/xilinx_emaclite.c
index 57a24f62e353..f7394a5160cf 100644
--- a/drivers/net/ethernet/xilinx/xilinx_emaclite.c
+++ b/drivers/net/ethernet/xilinx/xilinx_emaclite.c
@@ -926,8 +926,6 @@ static int xemaclite_open(struct net_device *dev)
xemaclite_disable_interrupts(lp);
if (lp->phy_node) {
- u32 bmcr;
-
lp->phy_dev = of_phy_connect(lp->ndev, lp->phy_node,
xemaclite_adjust_link, 0,
PHY_INTERFACE_MODE_MII);
@@ -938,19 +936,6 @@ static int xemaclite_open(struct net_device *dev)
/* EmacLite doesn't support giga-bit speeds */
phy_set_max_speed(lp->phy_dev, SPEED_100);
-
- /* Don't advertise 1000BASE-T Full/Half duplex speeds */
- phy_write(lp->phy_dev, MII_CTRL1000, 0);
-
- /* Advertise only 10 and 100mbps full/half duplex speeds */
- phy_write(lp->phy_dev, MII_ADVERTISE, ADVERTISE_ALL |
- ADVERTISE_CSMA);
-
- /* Restart auto negotiation */
- bmcr = phy_read(lp->phy_dev, MII_BMCR);
- bmcr |= (BMCR_ANENABLE | BMCR_ANRESTART);
- phy_write(lp->phy_dev, MII_BMCR, bmcr);
-
phy_start(lp->phy_dev);
}
--
2.7.4