Change the address cells as '2' so that the first cell
describes the i2c address offset of the clients.
This helps us to define the child nodes of all
clients under the same parent mfd node, instead of
adding separate mfd DT nodes.
Change the gpios reg value accordingly.
Signed-off-by: Satya Priya <[email protected]>
Reviewed-by: Stephen Boyd <[email protected]>
Reviewed-by: Rob Herring <[email protected]>
---
Changes in V13:
- Fixed nit.
Changes in V12:
- None.
Changes in V11:
- New patch added from V11.
Documentation/devicetree/bindings/mfd/qcom,pm8008.yaml | 12 ++++++------
1 file changed, 6 insertions(+), 6 deletions(-)
diff --git a/Documentation/devicetree/bindings/mfd/qcom,pm8008.yaml b/Documentation/devicetree/bindings/mfd/qcom,pm8008.yaml
index a89649c..a54d1ce0 100644
--- a/Documentation/devicetree/bindings/mfd/qcom,pm8008.yaml
+++ b/Documentation/devicetree/bindings/mfd/qcom,pm8008.yaml
@@ -39,7 +39,7 @@ properties:
interrupt-controller: true
"#address-cells":
- const: 1
+ const: 2
"#size-cells":
const: 0
@@ -48,7 +48,7 @@ properties:
maxItems: 1
patternProperties:
- "^gpio@[0-9a-f]+$":
+ "^gpio@0,[0-9a-f]+$":
type: object
description: |
@@ -61,7 +61,7 @@ patternProperties:
- const: qcom,spmi-gpio
reg:
- description: Peripheral address of one of the two GPIO peripherals.
+ description: Peripheral offset and address of one of the two GPIO peripherals.
maxItems: 1
gpio-controller: true
@@ -110,7 +110,7 @@ examples:
pm8008i@8 {
compatible = "qcom,pm8008";
reg = <0x8>;
- #address-cells = <1>;
+ #address-cells = <2>;
#size-cells = <0>;
interrupt-controller;
#interrupt-cells = <2>;
@@ -120,9 +120,9 @@ examples:
reset-gpios = <&pm8350c_gpios 4 GPIO_ACTIVE_LOW>;
- pm8008_gpios: gpio@c000 {
+ pm8008_gpios: gpio@0,c000 {
compatible = "qcom,pm8008-gpio", "qcom,spmi-gpio";
- reg = <0xc000>;
+ reg = <0x0 0xc000>;
gpio-controller;
gpio-ranges = <&pm8008_gpios 0 0 2>;
#gpio-cells = <2>;
--
2.7.4