From: Miao-chen Chou <[email protected]>
This splits the msft_do_{open/close} to msft_do_{open/close} and
msft_{register/unregister}. With this change it is possible to retain
the MSFT extension info irrespective of controller power on/off state.
This helps bluetoothd to report correct 'supported features' of the
controller to the D-Bus clients event if the controller is off. It also
re-reads the MSFT info upon every msft_do_open().
The following test steps were performed.
1. Boot the test device and verify the MSFT support debug log in syslog.
2. Power off the controller and read the 'supported features', power on
and read again.
3. Restart the bluetoothd and verify the 'supported features' value.
Signed-off-by: Miao-chen Chou <[email protected]>
Reviewed-by: Abhishek Pandit-Subedi <[email protected]>
Reviewed-by: Archie Pusaka <[email protected]>
Reviewed-by: Alain Michaud <[email protected]>
Signed-off-by: Manish Mandlik <[email protected]>
---
Changes in v6:
- Split msft_do_{open/close} into msft_do_{open/close} and
msft_{register/unregister}
Changes in v5:
- Rebase on ToT and remove extra blank line
Changes in v4:
- Re-read the MSFT data instead of skipping if it's initiated already
Changes in v3:
- Remove the accepted commits from the series
net/bluetooth/hci_core.c | 3 +++
net/bluetooth/msft.c | 55 +++++++++++++++++++++++++++++++++-------
net/bluetooth/msft.h | 4 +++
3 files changed, 53 insertions(+), 9 deletions(-)
diff --git a/net/bluetooth/hci_core.c b/net/bluetooth/hci_core.c
index fb296478b86e..8af0ea0934fa 100644
--- a/net/bluetooth/hci_core.c
+++ b/net/bluetooth/hci_core.c
@@ -3994,6 +3994,7 @@ int hci_register_dev(struct hci_dev *hdev)
queue_work(hdev->req_workqueue, &hdev->power_on);
idr_init(&hdev->adv_monitors_idr);
+ msft_register(hdev);
return id;
@@ -4026,6 +4027,8 @@ void hci_unregister_dev(struct hci_dev *hdev)
cancel_work_sync(&hdev->suspend_prepare);
}
+ msft_unregister(hdev);
+
hci_dev_do_close(hdev);
if (!test_bit(HCI_INIT, &hdev->flags) &&
diff --git a/net/bluetooth/msft.c b/net/bluetooth/msft.c
index b4bfae41e8a5..21b1787e7893 100644
--- a/net/bluetooth/msft.c
+++ b/net/bluetooth/msft.c
@@ -184,28 +184,36 @@ static void reregister_monitor_on_restart(struct hci_dev *hdev, int handle)
void msft_do_open(struct hci_dev *hdev)
{
- struct msft_data *msft;
+ struct msft_data *msft = hdev->msft_data;
if (hdev->msft_opcode == HCI_OP_NOP)
return;
+ if (!msft) {
+ bt_dev_err(hdev, "MSFT extension not registered");
+ return;
+ }
+
bt_dev_dbg(hdev, "Initialize MSFT extension");
- msft = kzalloc(sizeof(*msft), GFP_KERNEL);
- if (!msft)
- return;
+ /* Reset existing MSFT data before re-reading */
+ kfree(msft->evt_prefix);
+ msft->evt_prefix = NULL;
+ msft->evt_prefix_len = 0;
+ msft->features = 0;
if (!read_supported_features(hdev, msft)) {
+ hdev->msft_data = NULL;
kfree(msft);
return;
}
- INIT_LIST_HEAD(&msft->handle_map);
- hdev->msft_data = msft;
-
if (msft_monitor_supported(hdev)) {
msft->reregistering = true;
msft_set_filter_enable(hdev, true);
+ /* Monitors get removed on power off, so we need to explicitly
+ * tell the controller to re-monitor.
+ */
reregister_monitor_on_restart(hdev, 0);
}
}
@@ -221,8 +229,9 @@ void msft_do_close(struct hci_dev *hdev)
bt_dev_dbg(hdev, "Cleanup of MSFT extension");
- hdev->msft_data = NULL;
-
+ /* The controller will silently remove all monitors on power off.
+ * Therefore, remove handle_data mapping and reset monitor state.
+ */
list_for_each_entry_safe(handle_data, tmp, &msft->handle_map, list) {
monitor = idr_find(&hdev->adv_monitors_idr,
handle_data->mgmt_handle);
@@ -233,6 +242,34 @@ void msft_do_close(struct hci_dev *hdev)
list_del(&handle_data->list);
kfree(handle_data);
}
+}
+
+void msft_register(struct hci_dev *hdev)
+{
+ struct msft_data *msft = NULL;
+
+ bt_dev_dbg(hdev, "Register MSFT extension");
+
+ msft = kzalloc(sizeof(*msft), GFP_KERNEL);
+ if (!msft) {
+ bt_dev_err(hdev, "Failed to register MSFT extension");
+ return;
+ }
+
+ INIT_LIST_HEAD(&msft->handle_map);
+ hdev->msft_data = msft;
+}
+
+void msft_unregister(struct hci_dev *hdev)
+{
+ struct msft_data *msft = hdev->msft_data;
+
+ if (!msft)
+ return;
+
+ bt_dev_dbg(hdev, "Unregister MSFT extension");
+
+ hdev->msft_data = NULL;
kfree(msft->evt_prefix);
kfree(msft);
diff --git a/net/bluetooth/msft.h b/net/bluetooth/msft.h
index 6e56d94b88d8..8018948c5975 100644
--- a/net/bluetooth/msft.h
+++ b/net/bluetooth/msft.h
@@ -13,6 +13,8 @@
#if IS_ENABLED(CONFIG_BT_MSFTEXT)
bool msft_monitor_supported(struct hci_dev *hdev);
+void msft_register(struct hci_dev *hdev);
+void msft_unregister(struct hci_dev *hdev);
void msft_do_open(struct hci_dev *hdev);
void msft_do_close(struct hci_dev *hdev);
void msft_vendor_evt(struct hci_dev *hdev, struct sk_buff *skb);
@@ -31,6 +33,8 @@ static inline bool msft_monitor_supported(struct hci_dev *hdev)
return false;
}
+static inline void msft_register(struct hci_dev *hdev) {}
+static inline void msft_unregister(struct hci_dev *hdev) {}
static inline void msft_do_open(struct hci_dev *hdev) {}
static inline void msft_do_close(struct hci_dev *hdev) {}
static inline void msft_vendor_evt(struct hci_dev *hdev, struct sk_buff *skb) {}
--
2.33.0.309.g3052b89438-goog
Hi Manish,
> This splits the msft_do_{open/close} to msft_do_{open/close} and
> msft_{register/unregister}. With this change it is possible to retain
> the MSFT extension info irrespective of controller power on/off state.
> This helps bluetoothd to report correct 'supported features' of the
> controller to the D-Bus clients event if the controller is off. It also
> re-reads the MSFT info upon every msft_do_open().
>
> The following test steps were performed.
> 1. Boot the test device and verify the MSFT support debug log in syslog.
> 2. Power off the controller and read the 'supported features', power on
> and read again.
> 3. Restart the bluetoothd and verify the 'supported features' value.
>
> Signed-off-by: Miao-chen Chou <[email protected]>
> Reviewed-by: Abhishek Pandit-Subedi <[email protected]>
> Reviewed-by: Archie Pusaka <[email protected]>
> Reviewed-by: Alain Michaud <[email protected]>
> Signed-off-by: Manish Mandlik <[email protected]>
> ---
>
> Changes in v6:
> - Split msft_do_{open/close} into msft_do_{open/close} and
> msft_{register/unregister}
>
> Changes in v5:
> - Rebase on ToT and remove extra blank line
>
> Changes in v4:
> - Re-read the MSFT data instead of skipping if it's initiated already
>
> Changes in v3:
> - Remove the accepted commits from the series
>
> net/bluetooth/hci_core.c | 3 +++
> net/bluetooth/msft.c | 55 +++++++++++++++++++++++++++++++++-------
> net/bluetooth/msft.h | 4 +++
> 3 files changed, 53 insertions(+), 9 deletions(-)
patch has been applied to bluetooth-next tree.
Regards
Marcel