Hi
I'm having a very strange problem with lilo.
I run lilo it looks like it is writing the partition
table but it's not.
Problem begun in 2.4.10 and continued in 2.4.12
I double checked: lilo.config is good running lilo -V
shows that he is reading the config and writes the
partition table as instructed in lilo.conf but after
reboot nothing happens (i.e the new kernel )
I tried different lilo versions (21.7.5 , 22.0.2) and
the behaviour is unchanged
If I boot kernel 2.4.5 surprise lilo is actually
writing the partition table.
Any idea ?
Bye
__________________________________________________
Do You Yahoo!?
Make a great connection at Yahoo! Personals.
http://personals.yahoo.com
On Oct 23, 2001 07:29 -0700, szonyi calin wrote:
> I'm having a very strange problem with lilo.
> I run lilo it looks like it is writing the partition
> table but it's not.
> Problem begun in 2.4.10 and continued in 2.4.12
Well, there WAS a problem in 2.4.10 that would cause this, but it should be
fixed in 2.4.12.
Cheers, Andreas
--
Andreas Dilger \ "If a man ate a pound of pasta and a pound of antipasto,
\ would they cancel out, leaving him still hungry?"
http://www-mddsp.enel.ucalgary.ca/People/adilger/ -- Dogbert