Hello,
I recently got a MS-6321 dual processor motherboard which has Promise
FastTrak (IDE) RAID controller. When I attached two Maxtor 6L040J2 drives(40 gig)
to the two channels, it couldn't boot Linux-2.4.17 and hanged just after detecting
IDE controllers and just before partition detection.
I finally got what was wrong, I had to disable CMD640 bugfix option. Is this a
known issue? Since I couldn't find anything on google.
A second question: Is this true that ataraid only supports only one raid?
if not, what is the major number for second raid?
[/var/log/messages]
.....
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
Real Time Clock Driver v1.10e
block: 128 slots per queue, batch=32
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: IDE controller on PCI bus 00 dev 39
VP_IDE: chipset revision 6
VP_IDE: not 100%% native mode: will probe irqs later
VP_IDE: VIA vt82c686b (rev 40) IDE UDMA100 controller on pci00:07.1
ide0: BM-DMA at 0xb000-0xb007, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xb008-0xb00f, BIOS settings: hdc:DMA, hdd:DMA
PDC20265: IDE controller on PCI bus 00 dev 60
PDC20265: chipset revision 2
ide: Found promise 20265 in RAID mode.
PDC20265: not 100%% native mode: will probe irqs later
PDC20265: (U)DMA Burst Bit ENABLED Primary MASTER Mode Secondary MASTER Mode.
ide2: BM-DMA at 0xdc00-0xdc07, BIOS settings: hde:pio, hdf:pio
ide3: BM-DMA at 0xdc08-0xdc0f, BIOS settings: hdg:pio, hdh:pio
--------------HERE IS WHERE KERNEL HANGS.
and the rest of kernel log file when I disable cmd640 bugfix. Business as usual.
hda: FUJITSU MPG3409AT E, ATA DISK drive
hdc: DVDROM 10X, ATAPI CD/DVD-ROM drive
hdd: LITE-ON LTR-12101B, ATAPI CD/DVD-ROM drive
hde: MAXTOR 6L040J2, ATA DISK drive
hdg: MAXTOR 6L040J2, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
ide2 at 0xcc00-0xcc07,0xd002 on irq 11
ide3 at 0xd400-0xd407,0xd802 on irq 11
hda: 80063424 sectors (40992 MB) w/2048KiB Cache, CHS=4983/255/63, UDMA(100)
A Register SYNC_IN ERRDY_EN IORDY_EN PREFETCH_EN PIO(A) = 0
AP 11110000
B Register MB0 DMA(B) = 1 PB1 PB0 PIO(B) = 3
BP 00100011
C Register IORDYp MC0 DMA(C) = 1
CP 01000001
D Register
DP 00000000
hde: UDMA 5 drive0 0x004123f0 0x004123f0
hde: 78177792 sectors (40027 MB) w/1818KiB Cache, CHS=77557/16/63, UDMA(100)
A Register SYNC_IN ERRDY_EN IORDY_EN PREFETCH_EN PIO(A) = 0
AP 11110000
B Register MB0 DMA(B) = 1 PB1 PB0 PIO(B) = 3
BP 00100011
C Register IORDYp MC0 DMA(C) = 1
CP 01000001
D Register
DP 00000000
hdg: UDMA 5 drive2 0x004123f0 0x004123f0
hdg: 78177792 sectors (40027 MB) w/1818KiB Cache, CHS=77557/16/63, UDMA(100)
hdc: ATAPI DVD-ROM drive, 512kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.12
Partition check:
hda: hda1 hda2 < hda5 hda6 hda7 hda8 > hda3 hda4
hde: [PTBL] [4866/255/63] hde1 hde2
hdg: unknown partition table
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
ataraid/d0: ataraid/d0p1 ataraid/d0p2
Drive 0 is 38172 Mb (33 / 0)
Drive 1 is 38172 Mb (34 / 0)
Raid0 array consists of 2 drives.
Promise Fasttrak(tm) Softwareraid driver for linux version 0.03beta
Highpoint HPT370 Softwareraid driver for linux version 0.01
No raid array found
pci_hotplug: PCI Hot Plug PCI Core version: 0.3
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 8192 buckets, 64Kbytes
TCP: Hash tables configured (established 262144 bind 65536)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem) readonly.
....
--
Masoud Sharabiani
Software Developer, OEone Corporation
#103 - 290 St-Joseph Blvd.
Hull, Quebec J8Y 3Y3
819-770-3444 ext. 521
Unix: Your gun, Your bullet, Your foot, Your choice.
M$-CE/ME/NT: Same as Unix, BUT: No choice, and We Aim Higher.