Hi!
Not sure if this is a 3ware driver 'bug'. This is a 3ware 7810 with 8
100GB disks, configured hw raid0.
part of dmesg:
SCSI subsystem driver Revision: 1.00
3ware Storage Controller device driver for Linux v1.02.00.010.
scsi0 : Found a 3ware Storage Controller at 0x1090, IRQ: 5, P-chip: 1.3
scsi0 : 3ware Storage Controller
Vendor: 3ware Model: 3w-xxxx Rev: 1.0
Type: Direct-Access ANSI SCSI revision: 00
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
SCSI device sda: 1562951681 512-byte hdwr sectors (-299279 MB)
sda: unknown partition table
It should say something like 800GB, but says -299279 MB.
This is with the xfs 2.4.17 kernel. The raid works fine, it seemes just
cosmetic, but thought I'd better report it anyway.
Ookhoi
You need revision XX.15 > of the 3ware driver to handle 48 bit LBA.
I am running at present with 160GB drives on the 7810 and no
problem. There's also a firmware upgrade required of the
card to get 48 bit LBA to work properly. http://www.3ware.com has
the latest firmware.
Jeff
On Mon, Feb 11, 2002 at 02:05:20PM +0100, Ookhoi wrote:
> Hi!
>
> Not sure if this is a 3ware driver 'bug'. This is a 3ware 7810 with 8
> 100GB disks, configured hw raid0.
>
> part of dmesg:
>
> SCSI subsystem driver Revision: 1.00
> 3ware Storage Controller device driver for Linux v1.02.00.010.
> scsi0 : Found a 3ware Storage Controller at 0x1090, IRQ: 5, P-chip: 1.3
> scsi0 : 3ware Storage Controller
> Vendor: 3ware Model: 3w-xxxx Rev: 1.0
> Type: Direct-Access ANSI SCSI revision: 00
> Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
> SCSI device sda: 1562951681 512-byte hdwr sectors (-299279 MB)
> sda: unknown partition table
>
>
> It should say something like 800GB, but says -299279 MB.
>
> This is with the xfs 2.4.17 kernel. The raid works fine, it seemes just
> cosmetic, but thought I'd better report it anyway.
>
> Ookhoi
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to [email protected]
> More majordomo info at http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at http://www.tux.org/lkml/