Hello.
1. Hardware:
Intel Server Board STL2.
Network: onboard NIC "Intel(R) 82559 single chip PCI LAN controller"
Software:
Linux kernel up-to version 2.4.20pre9 + arp hidden patch.
2. dmesg:
...
Intel(R) PRO/100 Network Driver - version 2.1.15-k1
Copyright (c) 2002 Intel Corporation
e100: hw init failed
e100: Failed to initialize, instance #0
...
3. cat /proc/pci
...
Bus 0, device 3, function 0:
Ethernet controller: Intel Corp. 82557/8/9 [Ethernet Pro 100] (rev 8).
IRQ 18.
Master Capable. Latency=66. Min Gnt=8.Max Lat=56.
Non-prefetchable 32 bit memory at 0xfb101000 [0xfb101fff].
I/O at 0x5400 [0x543f].
Non-prefetchable 32 bit memory at 0xfb000000 [0xfb0fffff].
...
ps. eepro100 driver work, but bad.
dmesg:
...
<4>eepro100.c:v1.09j-t 9/29/99 Donald Becker http://www.scyld.com/network/eepro100.html
<4>eepro100.c: $Revision: 1.36 $ 2000/11/17 Modified by Andrey V. Savochkin <[email protected]
<6>eth0: OEM i82557/i82558 10/100 Ethernet, 00:D0:B7:B6:B2:8B, IRQ 18.
<6> Board assembly 000000-000, Physical connectors present: RJ45
<6> Primary interface chip i82555 PHY #1.
<6> General self-test: passed.
<6> Serial sub-system self-test: passed.
<6> Internal registers self-test: passed.
<6> ROM checksum self-test: passed (0x04f4518b).
...
...
eepro100: wait_for_cmd_done timeout!
eepro100: wait_for_cmd_done timeout!
eepro100: wait_for_cmd_done timeout!
eepro100: wait_for_cmd_done timeout!
eepro100: wait_for_cmd_done timeout!
eepro100: wait_for_cmd_done timeout!
...
And periodically freeze.
--
bye.
Andrey Nekrasov, SpyLOG.
Replying to Andrey Nekrasov:
> Intel Server Board STL2.
> Network: onboard NIC "Intel(R) 82559 single chip PCI LAN controller"
I have almost the same behavior here except that eepro100 works
without freezes. Maybe spylog servers' NIC load is much more higher
than mine :)
Intel support guys advised me to test both versions of e100 driver.
ftp://aiedownload.intel.com/df-support/2896/eng/e100-2.1.15.tar.gz
ftp://aiedownload.intel.com/df-support/2896/eng/e100-1.8.38.tar.gz
Unfortunately, I haven't tested it yet. My investigation shows that
the following fragment of e100_main.c code fails:
<code from="e100_hw_init">
if (!e100_wait_exec_cmplx(bdp, 0, SCB_RUC_LOAD_BASE))
return false;
</code>
we returning false here.
And I am stalled for now till the end of next week until the ACM ICPC
Qfinal is over :(
--
Paul P 'Stingray' Komkoff 'Greatest' Jr /// (icq)23200764 /// (http)stingr.net
When you're invisible, the only one really watching you is you (my keychain)
I believe the problem is due to the sleep mode bit,
I think the errata of Intel-STL2 documents it. We had a similar problem with our
STL2 based board,
clearing the sleep mode fixed it.
Paul P Komkoff Jr wrote:
> Replying to Andrey Nekrasov:
> > Intel Server Board STL2.
> > Network: onboard NIC "Intel(R) 82559 single chip PCI LAN controller"
>
> I have almost the same behavior here except that eepro100 works
> without freezes. Maybe spylog servers' NIC load is much more higher
> than mine :)
>
> Intel support guys advised me to test both versions of e100 driver.
>
> ftp://aiedownload.intel.com/df-support/2896/eng/e100-2.1.15.tar.gz
> ftp://aiedownload.intel.com/df-support/2896/eng/e100-1.8.38.tar.gz
>
> Unfortunately, I haven't tested it yet. My investigation shows that
> the following fragment of e100_main.c code fails:
>
> <code from="e100_hw_init">
> if (!e100_wait_exec_cmplx(bdp, 0, SCB_RUC_LOAD_BASE))
> return false;
> </code>
>
> we returning false here.
>
> And I am stalled for now till the end of next week until the ACM ICPC
> Qfinal is over :(
>
> --
> Paul P 'Stingray' Komkoff 'Greatest' Jr /// (icq)23200764 /// (http)stingr.net
> When you're invisible, the only one really watching you is you (my keychain)
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to [email protected]
> More majordomo info at http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at http://www.tux.org/lkml/