Hello,
I have this machine running either 2.4.18 or 19 with the same bad behavior.
I get from time to time the message in the Subject and if I do something
that uses the disk somewhat more it just reboots without any warning.
(for example if I use fsck or I type sync a lot when untarring .. )
Anyway the hardware configuration is like this:
2 X PIII 667MHz
MB chipset VIA VT82C693A/694x SMP board
512MB
2 Intel Etherexpress 82557
and the scsi adapter:
scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.8
<Adaptec 19160B Ultra160 SCSI adapter>
aic7892: Ultra160 Wide Channel A, SCSI Id=7, 32/253 SCBs
Vendor: QUANTUM Model: ATLAS10K2-TY184L Rev: DA40
Type: Direct-Access ANSI SCSI revision: 03
scsi0:A:0:0: Tagged Queuing enabled. Depth 253
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
(scsi0:A:0): 160.000MB/s transfers (80.000MHz DT, offset 127, 16bit)
SCSI device sda: 35860910 512-byte hdwr sectors (18361 MB)
Partition check:
sda: sda1 sda2 < sda5 sda6 sda7 sda8 >
It's really annoying to have the computer reboot without any warning or message to
track something ...
Teo