Hello,
Here goes the first release candidate of 2.4.22.
Please test it extensively.
Detailed changelog below.
Summary of changes from v2.4.22-pre10 to v2.4.22-rc1
============================================
<calum.mackay:cdmnet.org>:
o export the symbol "mmu_cr4_features" for XFree86
<lethal:unusual.internal.linux-sh.org>:
o sh: Define __flush_icache_all() for SH-3
o sh: Fix single stepping from looping
o sh: Add pgprot_nocached() definition
o sh: Further support for SecureEdge5410 and SH7751R
<marcelo:logos.cnet>:
o Delete: fs/noquot.c
o Cset exclude: [email protected]|ChangeSet|20030804201535|32414
o Changed EXTRAVERSION to -rc1
Adrian Bunk:
o fix a compile warning in acpi/system.c
o Fix circular dependency
Benjamin Herrenschmidt:
o ppc32: Fix PowerMac mediabay driver
Jeff Garzik:
o devices.txt: rename /dev/intel_rng to /dev/hwrandom
o [i810_rng] update docs to reflect new /dev name, and new pkg name
Manfred Spraul:
o fix select() with an xoffed tty
Theodore Y. T'so:
o Correct 64-bit write system call assignment
* Marcelo Tosatti <[email protected]>:
> Hello,
>
> Here goes the first release candidate of 2.4.22.
>
> Please test it extensively.
Still the same USB-problem I reported for pre5 and pre10:
kernel: hub.c: new USB device 00:02.2-2, assigned address 4
kernel: scsi1 : SCSI emulation for USB Mass Storage devices
kernel: Vendor: Maxtor 6 Model: Y120L0 Rev: 0811
kernel: Type: Direct-Access ANSI SCSI revision: 02
kernel: Attached scsi disk sda at scsi1, channel 0, id 0, lun 0
kernel: SCSI device sda: 240121728 512-byte hdwr sectors (122942 MB)
kernel: /dev/scsi/host1/bus0/target0/lun0: p1
kernel: WARNING: USB Mass Storage data integrity not assured
kernel: USB Mass Storage device found at 4
Now I start 'dump':
kernel: usb_control/bulk_msg: timeout
kernel: usb_control/bulk_msg: timeout
kernel: usb_control/bulk_msg: timeout
kernel: usb.c: USB disconnect on device 00:02.2-2 address 4
kernel: usb-storage: host_reset() requested but not implemented
kernel: scsi: device set offline - command error recover failed: host 1
channel 0 id 0 lun 0
kernel: 192
kernel: I/O error: dev 08:01, sector 81655440
lots of I/O errors following
Works fine with 2.4.21.
Could someone please fix that before 2.4.22 becomes stable?
Please CC me, thanks
--
Fridtjof Busse
I like to say "quark"! Quark, quark, quark, quark!
-- Calvin
Not enough info.
What usb controller do you have ? Which usb driver ?
ohci ? uhci ? ehci ? usb 2.0 ?
I reported this a long time ago on the usb lists, but
never got down to the bottom of the problem (my fault for
not following thru). However if i disable the usb 2.0
driver (i.e. not loading the ehci driver) which my external
storage is connected to, then everything works fine - albeit
it much more slowly. Appears to be a timing issue on some
usb <-> ide controller chips since not everyone is seeing this.
Mitch
Fridtjof Busse wrote:
>
> * Marcelo Tosatti <[email protected]>:
> > Hello,
> >
> > Here goes the first release candidate of 2.4.22.
> >
> > Please test it extensively.
>
> Still the same USB-problem I reported for pre5 and pre10:
>
> kernel: hub.c: new USB device 00:02.2-2, assigned address 4
> kernel: scsi1 : SCSI emulation for USB Mass Storage devices
> kernel: Vendor: Maxtor 6 Model: Y120L0 Rev: 0811
> kernel: Type: Direct-Access ANSI SCSI revision: 02
> kernel: Attached scsi disk sda at scsi1, channel 0, id 0, lun 0
> kernel: SCSI device sda: 240121728 512-byte hdwr sectors (122942 MB)
> kernel: /dev/scsi/host1/bus0/target0/lun0: p1
> kernel: WARNING: USB Mass Storage data integrity not assured
> kernel: USB Mass Storage device found at 4
>
> Now I start 'dump':
>
> kernel: usb_control/bulk_msg: timeout
> kernel: usb_control/bulk_msg: timeout
> kernel: usb_control/bulk_msg: timeout
> kernel: usb.c: USB disconnect on device 00:02.2-2 address 4
> kernel: usb-storage: host_reset() requested but not implemented
> kernel: scsi: device set offline - command error recover failed: host 1
> channel 0 id 0 lun 0
> kernel: 192
> kernel: I/O error: dev 08:01, sector 81655440
> lots of I/O errors following
>
> Works fine with 2.4.21.
> Could someone please fix that before 2.4.22 becomes stable?
>
> Please CC me, thanks
* <[email protected]>:
> Not enough info.
>
> What usb controller do you have ? Which usb driver ?
> ohci ? uhci ? ehci ? usb 2.0 ?
nforce2 with the ehci-driver.
> I reported this a long time ago on the usb lists, but
> never got down to the bottom of the problem (my fault for
> not following thru).
I also reported this problem there, but didn't get a reply at all.
> However if i disable the usb 2.0
> driver (i.e. not loading the ehci driver) which my external
> storage is connected to, then everything works fine - albeit
> it much more slowly. Appears to be a timing issue on some
> usb <-> ide controller chips since not everyone is seeing this.
Well, I only see this with 2.4.22-pre/rc, so this is definitly not a
hardware-problem, it runs just fine with 2.4.21 at 9950 kB/s.
And running my backup on USB 1.1 is not an option, way to slow.
--
Fridtjof Busse
panic("Lucy in the sky....");
2.2.16 /usr/src/linux/arch/sparc64/kernel/starfire.c
On Thu, Aug 07, 2003 at 12:05:06PM +0200, Fridtjof Busse wrote:
> * Marcelo Tosatti <[email protected]>:
> > Hello,
> >
> > Here goes the first release candidate of 2.4.22.
> >
> > Please test it extensively.
>
> Still the same USB-problem I reported for pre5 and pre10:
The usb-storage people should look into this (I've copied them on this.)
Hint, hint...
thanks,
greg k-h
>
> kernel: hub.c: new USB device 00:02.2-2, assigned address 4
> kernel: scsi1 : SCSI emulation for USB Mass Storage devices
> kernel: Vendor: Maxtor 6 Model: Y120L0 Rev: 0811
> kernel: Type: Direct-Access ANSI SCSI revision: 02
> kernel: Attached scsi disk sda at scsi1, channel 0, id 0, lun 0
> kernel: SCSI device sda: 240121728 512-byte hdwr sectors (122942 MB)
> kernel: /dev/scsi/host1/bus0/target0/lun0: p1
> kernel: WARNING: USB Mass Storage data integrity not assured
> kernel: USB Mass Storage device found at 4
>
> Now I start 'dump':
>
> kernel: usb_control/bulk_msg: timeout
> kernel: usb_control/bulk_msg: timeout
> kernel: usb_control/bulk_msg: timeout
> kernel: usb.c: USB disconnect on device 00:02.2-2 address 4
> kernel: usb-storage: host_reset() requested but not implemented
> kernel: scsi: device set offline - command error recover failed: host 1
> channel 0 id 0 lun 0
> kernel: 192
> kernel: I/O error: dev 08:01, sector 81655440
> lots of I/O errors following
>
> Works fine with 2.4.21.
> Could someone please fix that before 2.4.22 becomes stable?
>
> Please CC me, thanks
>
> --
> Fridtjof Busse
> I like to say "quark"! Quark, quark, quark, quark!
> -- Calvin
>
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to [email protected]
> More majordomo info at http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at http://www.tux.org/lkml/
> Well, I only see this with 2.4.22-pre/rc, so this is definitly not a
> hardware-problem, it runs just fine with 2.4.21 at 9950 kB/s.
Sounds exactly like the problem i was having. However the logical
thought behind it was that it must be either 1) a hardware specific
problem, or 2) a generic usb driver problem. Since only a handful
of people seen the problem, then this logically leads one to the
conclusion that our usb<->ide devices have some marginal timing
issues that are being triggered with the new code.
> And running my backup on USB 1.1 is not an option, way to slow.
Well in my case i opted for the slow backup rather than the no backup
if i wanted to move forward with the new kernels.
Cheers
Mitch
-------- Original Message --------
Subject: Re: Linux 2.4.22-rc1
Date: Thu, 7 Aug 2003 17:45:06 +0200
From: Fridtjof Busse <[email protected]>
To: [email protected]
CC: [email protected]
References: <[email protected]>
<[email protected]>
* <[email protected]>:
> Not enough info.
>
> What usb controller do you have ? Which usb driver ?
> ohci ? uhci ? ehci ? usb 2.0 ?
nforce2 with the ehci-driver.
> I reported this a long time ago on the usb lists, but
> never got down to the bottom of the problem (my fault for
> not following thru).
I also reported this problem there, but didn't get a reply at all.
> However if i disable the usb 2.0
> driver (i.e. not loading the ehci driver) which my external
> storage is connected to, then everything works fine - albeit
> it much more slowly. Appears to be a timing issue on some
> usb <-> ide controller chips since not everyone is seeing this.
Well, I only see this with 2.4.22-pre/rc, so this is definitly not a
hardware-problem, it runs just fine with 2.4.21 at 9950 kB/s.
And running my backup on USB 1.1 is not an option, way to slow.
--
Fridtjof Busse
panic("Lucy in the sky....");
2.2.16 /usr/src/linux/arch/sparc64/kernel/starfire.c